Abstract:This paper presents a mechatronic platform consists of a stimulator and a prosthesis hand holder, which aims at extrinsic flexible tactile sensor calibration and performance test for prosthesis hand application. The former is driven by a linear motor and the latter is driven by the combination of one 3 dimensions of freedom (DoF) motion stage and two rotation stages. A procedure is developed to calibrate flexible tactile sensors attached on the anthropomorphic prosthetic hand, whose surface is curved. Although the flexible tactile sensors can be easily integrated on to the mentioned curved surface due to its flexibility and compliance, they are usually flat fabricated and characterized under the working of flat situation. Curved surface sensor characterization is not directly available from the manufacturer. Furthermore, when tactile sensors are applied, there would be an elastic layer covered on top for protection and improvement of grasping ability. This elastic material essentially deteriorates the characteristics of the sensor under it, which is another important reason for establishing a platform to re-calibrate tactile sensor mounted on prosthetic hand. In this paper, two kinds of commercial tactile sensors are involved which are force sensing resistor (FSR) representing static measurement sensor and polyvinylidene fluoride (PVDF) sensor representing dynamic measurement sensor where a rigid rod with polydimethylsiloxane (PDMS) covered imitates prosthetic finger. The methodology of calibration compares the measured data obtained from tactile sensor with the one from a load cell fixed on the stimulator. The procedure of receptive-field measurement for tactile sensor on the prosthetic hand is shown and the equation for estimating the position and amplitude of surface load on top of elastic cover is established. Different combinations of tactile sensors are implemented on the rigid substance and two motion patterns of stimulator are performed on them, which are indentation and sliding. The performance of developed platform is also analyzed and it shows the ability of testing flexible tactile sensor for prosthesis hand.

Calibration of Optical Tweezers Based on Acousto-Optic Deflector and Field Programmable Gate Array

Calibrate the Non-Orthogonal Error of AFM with Two-Dimensional Self-Traceable Grating.

Optical Calibration of Holographic Acoustic Tweezers

Displacement Calibration of Optical Tweezers with Gravitational Acceleration

An Absolute Wavenumber Calibration Method Based on Characteristic Spectral Line and Constrained Fitting Phase

Displacement calibration of optical tweezers with absolute gravitational acceleration

3D Calibration of Microsphere Position in Optical Tweezers Using the Back-Focal-plane Interferometry Method.

Relaxing constraints on data acquisition and position detection for trap stiffness calibration in optical tweezers

Calibration of Acousto-Optic Interaction Geometry Based on the Analysis of AOTF Angular Performance

Accurate Calibration of Optical Tweezers close to a glass surface using interference rings in backscattered light

Optical Tweezers: A Comprehensive Tutorial from Calibration to Applications

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Optical tweezer generation using automated alignment and adaptive optics

Calibration of Coherent Optical Fiber Bundle with Lcd Screen for Deformation Measurements

Calibration of the oscillation amplitude of quartz tuning fork-based force sensors with astigmatic displacement microscopy

Dynamic Confocal Optical Probe Based on Time Difference Measurement

Optically Trapped Particle Dynamic Responses under Varying Frequency Sinusoidal Stimulus

A Mechatronic Platform for Calibration and Performance Test of Extrinsic Tactile Sensor on Prosthesis Hand.

Polymer-Based Self-Calibrated Optical Fiber Tactile Sensor

Actual Sensing Sensitivity and SNR Measurement of Optical Tweezers Based on Coulomb Force Input

Deflectometry based calibration of a deformable mirror for aberration correction and remote focusing in microscopy