Abstract:The generation of wear particles is now considered one of the most important failures in total arthroplasty. It is especially needed to study damage process of the particles at slight movement and lower load for long-term service of implanted materials. The wear and abrasion behavior of particles on Ti–6Al–4V coated with diamond-like carbon (DLC) were appropriately simulated in the present paper by fretting wear and nano-scratch test. The coatings with a thickness of 2.5 μm were deposited with an r.f.-plasma enhanced chemical vapor deposition method. The analytic techniques employed to assess DLC coatings characterization include SEM, AFM, Raman and IR spectroscopy. Assessment of hardness, elastic modulus, abrasion and adhesion of the coatings were performed using a Nano Indenter XP system with attachments of continuous stiffness measurements (CSM) and lateral force measurements (LFM). Tribological properties of the coatings were evaluated by a fretting wear test. It was concluded that the DLC coatings had a smooth surface morphology with a rms of 6.8 nm and possessed good adhesion to the substrate, they recovered fully elastic at lower load (60 mN) and were ploughed and delaminated only partially at higher load (400 mN). Nevertheless, there was wear debris concurrently generated during the nano-scratch and fretting test, which was more evident at high loads for a definite coatings, indicating an essential necessity of the work to improve the wear resistant of the coatings to avoid the generation of wear debris. The friction coefficient of DLC coatings against corundum obtained by fretting test decreased with the increase of relative humidity, it was below 0.1 in an aqueous condition, this may be beneficial to their biomedical applications in body fluids.

Evaluation of Scratch Resistance of Diamond-Like Carbon Films on Ti Alloy Substrate by Nano-Scratch Technique

Elasto-plastic Deformation and Fracture Mechanism of a Diamond-Like Carbon Film Deposited on a Ti–6Al–4V Substrate in Nano-Scratch Test

Analysis of nano-scratch behavior of diamond-like carbon films

ELASTIC-PLASTIC DEFORMATION AND FRACTURE MECHANISM ANALYSIS OF DIAMOND-LIKE CARBON FILMS DURING NANOSCRATCHING

A New Method for Evaluating the Scratch Resistance of Diamond-Like Carbon Films by the Nano-Scratch Technique

The Nano-Scratch Behaviour of Different Diamond-Like Carbon Film-Substrate Systems

Nano-scratching Process and Fracture Mechanism of Amorphous Carbon Films

Exploring Film Failure Mechanism and Scratch Toughness Characterization of Diamond-Like Carbon Film

Analysis on the Interfacial Mechanics of Microscratching Test for DLC-G95Cr18 Film-Substrate System

Nanoindentation and nanoscratch behaviors of DLC coatings on different steel substrates

Mechanical and Tribological Properties of Diamond-Like Carbon Films Deposited by Electron Cyclotron Resonance Microwave Plasma Chemical Vapor Deposition

Scratch Behavior of DLC Film Deposited by Plasma Based Ion Implantation & Deposition

Crack Evolution in Diamond-Like Carbon Films on Steel Substrates During Nano-Indentation

531 Damage Process on Scratch Test of TiC and TIN Coatings

Nano-scratch and Fretting Wear Study of DLC Coatings for Biomedical Application

Nanoindentation and scratching behaviors of diamond-like carbon films by coarse-grained molecular dynamics

Residual Stresses And Debonding Of Diamond Films On Titanium Alloy Substrates

Measurement of TiN Film Substrate Interfacial Adhesion by Scratching

Scratch Behavior of Multi-Layered Metallic Thin Films on Al2O3 Substrates

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Fracture Resistance Enhancement of Diamond-Like Carbon/nitrogenated Diamond-Like Carbon Multilayer Deposited by Electron Cyclotron Resonance Microwave Plasma Chemical Vapor Deposition