Abstract:Sequencing batch reactor (SBR) technology has become one of the commonly used treatment systems for municipal and industrial wastewater in the past decades. Cyclic activated sludge technology is one of the newly developed variations of SBR process. In this study, because the water quality situation of effluent under low-temperature and high-load conditions was unstable in Wang-hill Wastewater treatment plant, and the phenomena of exceeding discharge standard about ammonia-nitrogen (NH3-N) and total nitrogen (TN) were serious in winter, the different operation modes (operation cycle and aeration time) and control parameters were selected and optimized to improve nitrogen removal performance, respectively. The results indicated that the national first level B criteria of the effluent quality could be reached and the stable discharge could be achieved under the operation conditions of the C mode with 6 h per cycle [influent 2 h, aeration 2.5 h (aeration starting from 1.5 h after influent), settling 1 h, draw/idle 1 h], the average removal rates of chemical oxygen demand (CODcr), NH3-N, and TN in the reactor were 91.8, 75.6, and 62.9%, respectively. Furthermore, the dissolved oxygen (DO) level and mixed liquor suspended solids (MLSS) content in the aeration phase were both optimized on the basis of the preferred C mode. The best ranges of DO and MLSS concentration during the aeration phase as high as 2.0-3.0mg/L and 5,000-6,000mg/L are essential for the best nitrogen removal performance. The average removal rates of CODcr, NH3-N, and TN in the reactor were 90.3, 83.2, and 69.1%, respectively. Obviously, alternating operation mode combined with parameter optimization was the optimal nitrogen removal strategy for low-temperature and high-load wastewater. These data are of great practical significance for the scientific control and management of the wastewater treatment plant and for references of water engineering professionals.

Optimization DO and MLSS of CAST Process under Low Temperature and Optimal Mode Conditions

Factor� In�uencing �itrogen Remo�a� in a Decentra�i�ed Se�age Treatment Reactor

Enhanced Nitrogen Removal under Low-Temperature and High-Load Conditions by Optimization of the Operating Modes and Control Parameters in the Cast System for Municipal Wastewater

Performance of anammox UASB reactor treating low strength wastewater under moderate and low temperatures

Simulation and optimization of ammonia removal at low temperature for a double channel oxidation ditch based on fully coupled activated sludge model (FCASM): a full-scale study.

Removal Efficiency of Combined Treatment Process on Raw Water with High Ammonia Nitrogen and High Organic Pollutants

Study of influence of temperature decreasing in stages to nutrient removal in A2/O process

Effect of Four Aeration Modes on Pollutants Removal in a Composite CAST Treating Low Carbon Source Sewage

Effect of Staged Dissolved Oxygen Optimization on In-situ Sludge Reduction and Enhanced Nutrient Removal in an A2MMBR-M System

Pilot-scale Research on Treatment of Municipal Wastewater by Two-stage MBBR at Low Temperature

Simulation and Optimization of WWTP Based on Operation Decision Support System

Operational Qarameters to Keep High Nitrification Rate in Activated Sludge Process under Low Temperature

Development and application of an intelligent nitrogen removal diagnosis and optimization framework for WWTPs: Low-carbon and stable operation

Study of enhanced nitrogen removal efficiency and microbial characteristics of an improved two-stage A/O process

Research on influencing factors and operation optimization for CSTR partial nitrification at normal temperature

Optimization of operating parameters for sludge process reduction under alternating aerobic/oxygen-limited conditions by response surface methodology.

Enhance the Treatment of Low Strength Wastewater at Low Temperature with the Coexistence System of AnAOB and Heterotrophic Bacteria: Performance and Bacterial Community.

Operating Conditions Optimization and Characteristics Study of an AnMBR/A/OMBR Process for Coking Wastewater Treatment

Influence of temperature on performance and mechanism of advanced synergistic nitrogen removal in lab-scale denitrifying filter with biogenic manganese oxides

Operation Optimization of Step-feed A/O Process

Study on Operation Parameters Optimization and Denitrification Efficiency of Deep-Bed Denitrification Filter