Abstract:Wastewater treatment based on activated sludge processes faces a major challenge due to an increased number of people contributing to wastewater and changes in wastewater characteristics in regions with seasonal winter tourism. The combination of significant increases in carbon (COD) and nitrogen (N) loads by a factor of four to five within a short periode of time and low wastewater temperatures (<12 °C), represents a bottleneck in meeting essential effluent requirements. According to literature research, however, little attention has been paid to these special framework conditions for wastewater treatment. Based on this fact, a model-based simulation study of the wastewater treatment plant (WWTP) in Montafon (Austria) evaluates operational optimization approaches for the above-mentioned framework conditions and is intended to provide new insights for nitrification-optimized and energy-optimized wastewater treatment. The WWTP Montafon is designed for a COD load of 6250 kg d −1 , a daily dry weather water discharge of 12,700 m 3 d −1 and is a typical plant in a winter tourism region. The 5 studied smart operation approaches shown are a combination of two different aeration control strategies based on a time-controlled (i) or ammonia-based feedback aeration control (ABAC) (ii) for intermittent nitrification-denitrification and sludge removal control strategies based on a constant sludge concentration to 3 g L −1 (iii), a constant sludge retention time (SRT) to 20 days (iv) and a constant sludge retention time to 20 days combined with a higher level sludge concentration control to max. 3 g L −1 (v). The simulation results show that a combination of a time-controlled aeration strategy and controlling the sludge concentration to a constant 3 g L −1 is not recommended in order to comply with the emission limits. Under the mentioned influent conditions, ABAC control alone does not inevitably lead to a nitrification-optimized process and reduction in energy consumption. Sufficient nitrifying bacteria in the activated sludge are the key to a nitrification optimized process and reduction of energy consumption for aeration. Hence, a combination of an intermittent aeration control based on ammonium measurement and a constant sludge retention time to 20 days is preferable for nitrification capacity and is the most energy-efficient control strategy to obtain required COD and N effluent quality. An average energy consumption of 57–63 Wh PE 120 −1 d −1 for the aeration is to be expected for combinations of (i,iv), (ii, iii) (ii,iv) and (ii,v) which is low in relation to the influent challenges and to plants with higher wastewater temperatures (>12 °C) between 27 Wh PE 120 −1 d −1 and 121 Wh PE 120 −1 d −1 according to literature. The approach with a time-controlled intermittent aeration and a SRT to constant 20 days was implemented at the WWTP Montafon and confirms the results of the associated simulation. According to this simulation study, a 35 % increase in nitrification capacity in existing WWTPs designed as activated sludge processes can be achieved through optimized operating conditions without additional high investments.

Simulation and optimization of ammonia removal at low temperature for a double channel oxidation ditch based on fully coupled activated sludge model (FCASM): a full-scale study.

Performance of anammox UASB reactor treating low strength wastewater under moderate and low temperatures

Model Reduction Based on Time-Scale Decomposition for Wastewater Treatment Process

Simulation and Optimization of A Full-Scale Carrousel Oxidation Ditch Plant for Municipal Wastewater Treatment

An efficient hydrodynamic-biokinetic model for the optimization of operational strategy applied in a full-scale oxidation ditch by CFD integrated with ASM2

Optimization of biological nitrogen removal in full-scale municipal WWTPs using activated sludge model simulation

Modeling and simulation of an extended ASM2d model for the treatment of wastewater under different COD: N ratio

Simulation and Optimization of WWTP Based on Operation Decision Support System

Study on a Discrete-Time Dynamic Control Model to Enhance Nitrogen Removal with Fluctuation of Influent in Oxidation Ditches.

Model-based assessment of mainstream nitrate/nitrite-dependent anaerobic methane oxidation and Anammox process in granular sludge at low temperature

Mathematical Simulation of Feedforward Control for Nutrient Removal in Anaerobic-Anoxic-oxic Processes.

Comparison and optimization of a NH4+-N removal model of a tidal-flow constructed wetland in low temperature seasons

A simulation-based integrated approach to optimize the biological nutrient removal process in a full-scale wastewater treatment plant

Enhanced Nitrogen Removal under Low-Temperature and High-Load Conditions by Optimization of the Operating Modes and Control Parameters in the Cast System for Municipal Wastewater

Model-based dynamic simulation study to boost the WWTP performance in winter tourism regions

Modeling and Simulation of a Biological Process for Treating Different COD:N Ratio Wastewater Using an Extended ASM1 Model

Efficient municipal wastewater treatment by oxidation ditch process at low temperature: Bacterial community structure in activated sludge

Modeling and simulation of the biological process for treating wastewater with a low COD:N ratio under different dissolved oxygen conditions using an extended ASM2d model

Simulating a Cyclic Activated Sludge System by Employing a Modified ASM3 Model for Wastewater Treatment.

A Model-Based Approach to Study the Effect of Temperature in Plant-Wide Biological Wastewater Treatment Plants

Development and application of an intelligent nitrogen removal diagnosis and optimization framework for WWTPs: Low-carbon and stable operation