Abstract:The ability of wood–plastic composites (WPCs) to withstand various loads and resist plastic failure is attracting more and more interest due to the global increase in demand for WPCs by over 6 million tons per year. Among the most important and innovative research methods are those based on fracture mechanics—their results enable material designers to optimize the structures of these hybrid polymer composites at the nano, micro and macro levels, and they allow engineers to more accurately evaluate and select functional, sustainable, long-lasting and safe product designs. In this study, standard single-edge notched bending (SENB) tests were used to analyze the fracture toughness of two different extruded WPCs along the longitudinal (L) and transverse (T) directions of extrusion. In addition to their resistance to crack propagation, critical fracture criteria, initial contact stiffness, fracture parameters and fracture surfaces, the mechanical properties of these composites were also investigated. The results showed that WPC-A coded composites withstood higher loads until failure in both directions compared to WPC-B. Despite the larger data spread, both types of composites were more resistant to crack propagation in the T direction. Mode II of crack propagation was clearly visible, while mode III was not as pronounced. The experimental results and the numerical finite element (FE) model developed up to 58% of the maximum load correlated well, and the obtained deformation curves were best approximated using cubic equations (R2 > 0.99). The shear stress zone and its location, as well as the distribution of the equivalent stresses, had a major influence on crack propagation in the fracture process zone (FZP).

Fracture Toughness of Wood—Wood and Wood—FRP Bonded Interfaces under Mode-II Loading

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

The over-notched flexure test method for determining the fracture toughness and bridging law of laminates

On the Fracture Resistance of Adhesively Jointing Structures

Mode Ii Fracture Testing Method for Highly Orthotropic Materials Like Wood

Fracturing behaviors of FRP-strengthened concrete structures

A New Flexural Strength Model of CFRP-strengthened RC Beams with Intermediate Crack Induced Debonding Failure

Experimental and numerical investigation on test methods for mode II fracture of composite‐titanium adhesively bonded structures

Assesment of Proposed Models for Determining Allowable Frp Tensile Strain for Mitigation of Debonding Failure in Frp-Strengthened Rc Beams

Estimation of fracture behavior of CFRP/CFRP adhesively bonded joints under mixed-mode conditions using a cohesive zone model

Intermediate crack-induced debonding in RC beams and slabs

EXPERIMENTAL STUDY ON FLEXIONAL BEHAVIOR OF TIMBER BEAM STRENGTHENED WITH FRP

Experimental and Numerical Investigation of the Fracture Behavior of Extruded Wood–Plastic Composites under Bending

Characterization of mode II delamination behaviour of poplar plywood and LVL

Effect of crack size, thickness and span on the transverse mode I fracture characteristics of laminated flattened-bamboo lumber

Determination of Interface Fracture Toughness of Adhesive Joint Subjected to Mixed-Mode Loading Using Finite Element Method

Collaborative Model in Brain-Computer Integration

PHASE FIELD BASED COHESIVE ZONE FRACTURE APPROACH TO MODEL ANISOTROPIC EFFECT AND INTERFACE FRACTURE IN FIBER REINFORCED POLYMER COMPOSITES

Cohesive Zone Modeling of the Interface Fracture in Full-Thermoplastic Hybrid Composites for Lightweight Application

Experimental Investigation and Numerical Simulation of Bonded, Bolted, and Hybrid Joints in CFRP Laminates Under Tensile Loading

On the high fracture toughness of wood and polymer-filled wood composites – Crack deflection analysis for materials design