Abstract:The Pancharatnam–Berry (PB)-phase liquid crystal (LC) planar optical elements, featuring large apertures and a light weight, are emerging as the new generation optics. The primary method for fabricating large-aperture LC planar optical elements is through photo-alignment, utilizing polarization laser direct writing. However, conventional polarization direct writing suffers from an inertia-induced stopping step during splicing, leading to suboptimal optical effects. Here, we propose a novel highly efficient method for arbitrary polarization patterning, significantly reducing interface splicing errors in these optical elements. (We call it dynamic polarization patterning technology). This process involves simultaneous mobile splicing and real-time generation of different polarization patterns for exposure, eliminating the inertia-related splicing interruption. As a demonstration, we fabricated a lens with an aperture of approximately 1 cm within 30 min at 633 nm. Furthermore, we developed a 100% fill-factor lens array (3 × 3) with an element lens diameter of approximately 7 mm within 1.5 h at 532 nm. Their focal lengths were uniformly set at 30 cm, demonstrating superior convergence capabilities within their designated working wavelengths, alongside commendable performance in converging light across various other wavelengths. Our measurements confirmed the good focusing performance of these samples. The convergence spot size of the lens deviated by approximately 40% from the theoretical diffraction limit, whereas the lens array exhibited a deviation of around 30%. The dynamic polarization direct writing during uniform platform movement reduced splicing errors to a mere 100–200 nm. The enhancement in imaging quality can be primarily attributed to the innovative use of mobile polarization splicing exposure technology, coupled with the inherent self-smoothing properties of LC molecules. This synergy significantly mitigates the impact of seam diffraction interference.

Self-aligning polarization strategy for making side polished polarization maintaining fiber devices.

Development of Method for Polarization Alignment of PANDA Polarization Maintaining Fiber

Research on Polarization Parameters Testing System

Alignment Technique for Polarization-Based Optical-Systems

Tri-Section Side-Polished Polarization Maintaining Fibre Polarizer

In‐line Fiber‐optical Polarizer with High‐extinction Ratios and Low‐insertion Loss

Simulation and Experiment on Automatic Polarization Alignment of Fine Polarization Maintaining Fibers

In-line High Efficient Fiber Polarizer Based on Surface Plasmon

Polarization-Dependent Loss of Long-Period Fiber Grating Fabricated by Dual-Side Exposure Method

Self-adapt Polarization Controller Using Birefringence Effect by Fiber Squeezer

Method Optimization and Determining Polarization Direction Experiment of Ultra-fine Polarization Maintaining Fiber

Planar fiber-chip-coupling using angle-polished polarization maintaining fibers

Interferometric polarization compensation based on one single polarization-maintaining fiber

Investigation on the Polarization Dependence of An Angled Polished Multimode Fibre Structure

Advances in Silica-Based Large Mode Area and Polarization-Maintaining Photonic Crystal Fiber Research

Method of improving optical poling efficiency in polymer films.

Polarization-dependent micro-structure fabrication with direct femtosecond laser writing on plastic polarizer films.

Polarization Maintain Fiber Couplers with Novel Transmission Characteristics

Dynamic Polarization Patterning Technique for High-Quality Liquid Crystal Planar Optics

Modulating Linearly Polarized Light into a Full Poincaré Beam by Stress-Engineered Optical Element

Self-interference Polarisation Pantographer Method to Fabricate Pancharatnam-Berry Phase Optical Elements