Abstract:Improving on the sealing and high pressure conditions of traditional hydrothermal method, vertical ZnO nanorod arrays were synthesized on indium tin oxide substrate by employing Zn(NO3)2 x 6H2O, (CH2)4N6 as the starting materials in the presence of polyethylenimine(PEI) at ambient pressure and low temperature (92 degrees). Between the substrate and the nanorods, a layer of ZnO flim was prepared as buffer layer and seed layer. The ZnO film was gained by spin-coating zinc acetate solution on indium tin oxide substrate, then annealed at 350 degrees C for 20 min, which can make zinc acetate decompose into zinc oxide. The zinc acetate spin-coating and decomposition procedure was carried out twice to ensure a complete and uniform coverage of ZnO seeds. The second layer was annealed at 500 degrees C for 30 mini Different spin-coating speeds were adopted, one was 2500 r x min(-1), and the other was 5000 r x min(-1). XRD result indicated that the seed layer with 5000 r x min(-1) has better alignment than the layer with 2500 r x min(-1). The aligned seeds with 5000 r x min(-1) show only a (002) reflection, indicating their complete c-axis texturing, whereas the spin-coated seeds give a powder pattern because they rest at all angles on the substrate. SEM result shows that the layer is made up of grains with an the average size of about 30 nm. Well-aligned ZnO nanorod arrays were synthesized by putting the substrate with ZnO seeds into the precursor solutions vertically for one hour. The nanorod arrays were taken out and rinsed with clean ethanol and pure-water for several times, blown dry with a stream of nitrogen, then annealed at 400 degrees C for 30 min in order to wipe off the organic solvent. At room-temperature, the SEM and XRD were measured. SEM results indicate that the crystal structure of most of ZnO nanorods is hexagonal wurtzite crystallographic phase structure, mainly vertical to the substrate. ZnO nanorods have good crystallization, the diameter of the rods is around 40 nm, and the length is above micrometer. The XRD results showed the nanorod arrays have (002) and (004) angles, and the (002) is quite strong. Absorption spectra of the nanorod arrays shows ZnO essence absorption and strong ultraviolet absorption, indicating that ZnO has good quality. Optical properties were studied, and the excitation spectra of the nonorod arrays showed a strong and narrow peak at 387 nm with FWHM smaller than 30 nm and a weak blue peak.

Preparation of ZnO Nanorods and Optical Characterizations

Facile synthesis of Zn 1−x Cu x O nanorods with a very broad visible band

Preparation and photoluminescence of ZnO nanorods

Study on Preparation and Photoeletric Properties of ZnO Nanorods

Preparation and characterization of ZnO nanorods

Preparation and Photoluminescence of ZnO with Nanostructure by Hollow-Cathode Discharge

Synthesis and Optical Characterizations of ZnO Nanorods

Research on Preparation of ZnO Nanorods by Hydrothermal Steam Method

ZnO Nanorods Prepared by Magnetron Sputtering and Thermal Oxidation and Their Photoluminescence

Preparation and Photoluminescence Properties of ZnO Nanorod Arrays on Zinc Substrates

Preparation And Photocatalytic Property Of Zno Nanorods With Uniform Morphology

Preparation and Characterization of Single-crystal ZnO Nanorods Via a H2O2-assisted Hydrothermal Method

Preparation and Optical Property of Mn-Doped ZnO Nanorods

Photoluminescence Properties of ZnO Nanorods Prepared under Low Temperature

Synthesis, Characterization and Optical Properties of Nanostructured ZnWO 4

Preparation and Photoluminescent Properties of Al Doped and Al-N Codoped ZnO Nanorods

Preparation of ZnO/ZnS Core-Shell Nanorods and Its Optical Properties

Preparation of ZnO nanorods through wet chemical method

Highly Monodispersed ZnO Nanorods: Preparation and Optical Properties

Hydrothermal Preparation and Photoluminescence Property of Co-Doped ZnO Nanorods

[The Preparation and Characterization of 1-D Orderly ZnO Nanorod Arrarys].