Abstract:Electrospinning is a simple and straightforward process by which continuous polymer fibers with diameter ranging from a few nanometers to microns can be produced using an electrostatically driven jet of polymer solution(or polymer melt).In the present contribution,ultrafine fibers were spun from polyethylene oxide(PEO)/water solution using a homemade electrospinning set-up.The effects of the concentration of polymer solution and spinning voltage on the morphology of fibers and distribution of fiber diameters were investigated.A more comprehensive and systematic understanding of process parameters of the electrospinning was obtained.In this experiment fibers with diameter ranging from 100 nm to 1000 nm were obtained.The results showed that both the concentration of polymer solution and spinning voltage were important factors characterizing the morphology of fibers and distribution of fiber diameters.The concentration of polymer solution played an important role in the morphology of the fibers obtained.Lower concentration of polymer solution(0.04 kg/L PEO aqueous solution) tended to facilitate the formation of fibers with beads,and smooth and uniform fibers without beads were obtained at the concentration of 0.05 kg/L PEO aqueous solution and 0.06 kg/L PEO aqueous solution.As other process parameters were fixed,raising the concentration of polymer solution resulted in the increasing of average diameter of fibers.Spinning voltage also had an influence on the average diameter of fibers.Thinner fibers were received on the target with higher voltage applied on the nozzle at a given flow rate.The morphology of fibers electrospun from PEO was observed and analyzed by scanning electron microscopy(SEM).

Study on Processing of Gelatin Ultrafine Fibers

Electrostatic Spinning of Aqueous Gelatin Solution

Effect On The Electrospinnability By Adding Surfactant In Gelatin Aqueous Solution

Influence of SDS and ethanol on forming process of gelatin ultrafine fiber

Electrospinnability of Gelatin Aqueous Solution with the Addition of Sodium Docecyl Sulfate and Ethanol

Research Progress in Electrospinning of Gelatin Micrometer and Nano Scale Fibers

STUDIES ON ONE-STEP ELECTROSPINNING FOR PREPARING CROSSLINKED GELATIN FIBERS

Characterization of Gelatin/zein Nanofibers by Hybrid Electrospinning

Development of Hybrid Electrospun Nanofibers: Improving Effects of Cellulose Nanofibers (CNFs) on Electrospinnability of Gelatin

Experimental Investigation of the Effect of Processing Parameters on the Formation of Electrospun Polyethylene Oxide Nanofibers

Preparation and Properties of Poly (vinyl Alcohol) Nanofibers by Electrospinning

Effect of the composition and electrospinning time of gelatin solutions in acetic acid on their rheological properties and nanofiber morphology

Characterization of Gelatin/zein Films Fabricated by Electrospinning Vs Solvent Casting

Study on Wettability, Mechanical Property and Biocompatibility of Electrospun Gelatin/zein Nanofibers Cross-Linked by Glucose

Effect of Different Surfactants on Performance of Electrospun Ultrafine Nanofiber

Preparation and Properties of Wet-Spun Agar Fibers.

Preparation of YIG Single Crystal Nanofibers Via an Electrospinning Technique

Microstructure and Property of Electrospun Regenerated Silk Fibroin/gelatin Nanofibers

Preparation and characterization of EPDM ultrafine fibers by electrospinning

Optimization design and properties of PVA/GEL nanofibers

Preparation and condition optimization of electrospun Gliadin nanofibers