Abstract:Abstract ITO was prepared by mixing gradient In 2 O 3 and SnO 2 powders using solid phase reaction manner. Using electron beam gun tool, ITO films with varied thicknesses were fabricated. The structure, electrical and optical parameters of the prepared films were studied. XRD patterns were used to establish the micro-structural parameters (lattice strain and crystallite size). The SEM shows improvement of grain size with the increase of the film thickness. The electrical parameters of ITO films were measured by means of the standard four-point probe method. It was found that when the film thickness increases from 75 nm to 375 nm, the resistivity decreases to lower value of 1.65×10 -4 Ω.cm and slightly increases to 1.93 ×10 -4 Ω.cm at thickness of 375 nm. The ITO films with lower electrical properties are appropriate for high-efficiency CdTe solar cells. In terms of spectral ellipsomeric, three optical layer models (adhesive layer of the substrate/B-spline layer of ITO film/surface roughness layer) were applied to estimate the film thickness with high accuracy. The absorption coefficient and energy gap were calculated from the transmission and reflection spectra in the strong absorption region. As the film thickness increases, the optical energy gap was found to increase from 3.56 eV to 3.69 eV. In terms of Hall-effect measurements, both carrier concentration and hall mobility were determined. In addition, influences of ITO layers with various thicknesses on the performance of CdS/CdTe solar cells were checked. When the ITO window layer thickness is 325 nm, J sc = 17 mA/cm 2 , V oc = 0.82 V, and FF = 57.4%, the calculated highest power conversion efficiency (PCE) is 8.6%.

The Electrical, Optical Properties of CdTe Polycrystalline Thin Films Deposited under Ar–O2 Mixture Atmosphere by Close-Spaced Sublimation

Studies of Structure,Composition and Photoelectric Properties of CdTe Thin Film Grown by Vacuum Sublimation

Microstructure, electrical and optical properties of Cd-doped CdTe thin films deposited by close-spaced-sublimation

The role of O2 in CdSeTe thin film deposition and CdSeTe/CdTe solar cell performance

Microstructure and optical properties of CdTe thin films prepared by close spaced sublimation method at various growth temperatures

Effects of Oxidation and CdCl2 Treatment on the Electronic Properties of CdTe Polycrystalline Films

The study on saturation current and ideality factor of CdTe solar cell based on CdS window layer deposited with hydrogen peroxide

Influence of deposition time in CdTe thin film properties grown by Close-Spaced Sublimation (CSS) for photovoltaic application

High-efficiency CdTe-based Thin-Film Solar Cells with Unltrathin CdS:O Window Layer and Processes with Post Annealing

Improving CdTe‐Based Thin‐Film Solar Cell Efficiency with the Oxygenated CdSe Layer Prepared by Sputtering Process

Structure and Optical Properties of Te-doped CdTe Thin Films

Physico-chemical analysis of the properties and stability of CdS and CdS:O to be applied in thin-film solar cells

A microstructural study on the surface and interface of CdTe/CdS solar cells

[Study on back contact layer of CdTe solar cell by XPS]

Properties of CdTe layers deposited by a novel method -Pulsed Plasma Deposition

Structural and optical properties of Te doped CdS films

Synthesis of CdTe thin films on flexible metal foil by electrodeposition

Structure, Electrical and Optical Properties of ITO Thin Films and Their influence on Performance of CdS/CdTe Thin-Film Solar Cells

Structural and Thermodynamic Properties of Pb-Cd-Te Thin Films: Experimental Study and DFT Analysis

Synthesis and characterization of CdTe/CdSe thin film on glass/ITO by electrodeposition at room temperature

Influence of sputtering power on structural, optical and electrical properties of CdTe thin films prepared by DC magnetron sputtering