Abstract:China produces large amounts of sewage sludge and agricultural waste every year. In line with the concepts of economic and environmental sustainability, the disposal of these wastes has become increasingly urgent. This paper proposes a feasible way to use river sediments, sewage sludge, and wheat straw as raw materials for sintered shale bricks. The critical processes of best humidity conditions, molding pressure, and sintering temperature were studied and analyzed to determine the optimal production parameters. Moreover, the physical and mechanical properties were investigated to assess their suitability as a partial replacement for the shale in fired-shale bricks. The results showed that moist mixtures with the maximum dry density, the molding pressure of 2 MPa, and a sintering temperature of 1050 °C were the optional condition to sinter high-quality bricks. Overall, the mechanical strength of bricks tended to slightly decrease with the 10–30% substitution of shale by river sediments, which showed a sharp fall with the 1–3% incorporation of sewage sludge and wheat straw, implying that massive organic matters could enhance the porosity of bricks during the sintering process. The bulk density, thermal conductivity coefficient, and drying shrinkage tended to decrease, whereas water absorption increased as three raw materials increased. Additionally, the sewage sludge and wheat straw have a positive inhibiting effect on the sintering shrinkage due to the expansion burned from massive organic matter. At the replacement level of 10–30% river sediments, 1–2% sewage sludge, and 1% wheat straw, bricks with the characteristics of low thermal conductivity, lightweight, and high strength were successfully manufactured according to the Chinese Standards.

Preparation of Pottery from Shale

Impact of the Mineral Composition and Sintering Temperature on the Synthesis of Anorthite Ceramics

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Preparation and physical properties of foamed ceramics from shale residue

A Kaolinitic Clay from Yantai (china): Improvement of Properties and Microstructure

Study on Preparation of Ceramsite from Shale Slag and Its Application

Study on Technological Conditions of Red Mud-Coal Gangue Lightweight Pottery Sand

Experimental Study on Mechanical Properties of Soft Clay Stabilized by Industrial By-Products

Archaeometric characterization of pottery from the Houjiazhai site (ca. 7.3-5.7 ka BP), Anhui Province, China

Characterization and properties of Chinese red clay for use as ceramic and construction materials

New environmentally friendly substance formulation based on steel slag for the manufacture of stoneware

The Preparation and Properties of Clay Bonded Silicon Carbide by Using Silicon Carbide Dusting Powder

Utilization of river sediment, sewage sludge and wheat straw as the primary raw material in sintered-shale bricks

Preparation, characteristics and mechanisms of the composite sintered bricks produced from shale, sewage sludge, coal gangue powder and iron ore tailings

Preparation and characterization of porous anorthite ceramics from red mud and fly ash

Physical and Mechanical Properties of Sintered Clay Body Mixed with Sewage Sludge

Chemometric Study Of Neolithic Pottery In China

Preparation of High Strength and Lightweight Wall Materials Using Oil Shale Ash As Raw Materials

Research on the Characterization of A Porcelainised Material Fabricated by Adding A Small Amount of Anorthite Chamotte

Properties and Sintering Behavior of Ceramics Used Fly Ash and Red Mud As Raw Materials