Abstract:The effect of activation environment (N2, H2 and H2S/H2) on the hydrocracking performance of a NiMo/Al catalyst was studied at 380 °C and 3.5 MPa using octacosane (C28). The catalyst physical structure and acidity were characterized by BET, XRD, SEM-EDX and FTIR techniques. The N2 activation generated more active nonsulfided NiMo/Al catalyst relative to the H2 or H2S activation (XC28, 70–80% versus 6–10%). For a comparison, a NiMo/Si-Al catalyst was also tested after normal H2 activation and showed higher activity at the same process conditions (XC28, 81–99%). The high activity of the NiMo/Al (N2 activation) and NiMo/Si-Al catalysts was mainly ascribed to a higher number of Brønsted acid sites (BAS) on the catalysts. The hydrocracking of cobalt wax using Pt/Si-Al and Pt/Al catalysts confirmed the superior activity of the Si-Al support. A double-peak product distribution occurred at C4–C6 and C10–C16 on all catalysts, which illustrates secondary hydrocracking and faster hydrocracking at the middle of the chain. The nonsulfided NiMo/Al and Pt/Al catalysts, and NiMo/Si-Al catalyst produced predominantly diesel (sel. 50–70%) and gasoline range (sel. > 50%) hydrocarbons, respectively, accompanied by some CH4 and light hydrocarbons C2–C4. On the other hand, the hydrocarbon distribution of the Pt/Si-Al varied with conditions (i.e., diesel sel. 87–90% below 290 °C or gasoline sel. 60–70% above 290 °C accompanied by little CH4) The dependence of the isomer/paraffin ratio on chain length was studied as well. The peak iso/paraffin value was observed at C10–C13 for the SiAl catalyst.

The Hydrocracking of N-Decane over Bifunctional Ni-H3PW12O40/SiO2 Catalysts

Alumina supported H3PW12O40 and Ni catalysts for hydrocracking of n-decane

Direct Synthesis, Characterization and Catalytic Performance of Non-Sulfided Ni–CsxH3−xPW12O40/SiO2 Catalysts for Hydrocracking of N-Decane

Hydrocracking of N-Decane over Non-Sulfided Ni-Csxh3-Xpw12o40/Al2o3 Catalysts

Influence of H4SiW12O40 loading on hydrocracking activity of non-sulfide Ni–H4SiW12O40/SiO2 catalysts

Influence of Cs Substitution on the Structural Properties and Catalytic Performance of Ni-H3PW12O40/SiO2 Catalysts

Deep Hydroisomerization of n-Hexadecane over NiWS/SAPO-11 Catalyst: Size Effect of the Support and Revelation of the Reaction Network

High Catalytic Activity and Stability Quasi Homogeneous Alkali Metal Promoted Ni/SiO2 Aerogel Catalysts for Catalytic Cracking of N-Decane

Hydroisomerization of N-Decane over the Pd/ZSM-22 Bifunctional Catalysts: the Effects of Dynamic and Static Crystallization to the Zeolite

Hydrocracking of Polyolefin Thermal Cracking Waxes Over Ni-loaded Molecular Sieve Catalysts

Hydrocracking of Octacosane and Cobalt Fischer–Tropsch Wax over Nonsulfided NiMo and Pt-Based Catalysts

Hydrocracking of Bio-Alkanes over Pt/Al-MCM-41 Mesoporous Molecular Sieves for Bio-Jet Fuel Production

Role of Acidity in Catalytic Cracking of N-Decane over Supported Pt-based Catalysts

Hydrocracking diversity in n-dodecane isomerization on Pt/ZSM-22 and Pt/ZSM-23 catalysts and their catalytic performance for hydrodewaxing of lube base oil

Bifunctional Ni2P/SAPO-11 Catalyst for Simultaneous Hydroisomerization of 1-Hexene and Hydrodesulfurization of Thiophene

Coking and Gas Products Behavior of Supercritical N-Decane over NiO Nanoparticle/nanosheets Modified HZSM-5

Hydroisomerization of N -Heptane over Bimetal-Bearing H 3 PW 12 O 40 Catalysts Supported on Dealuminated USY Zeolite

Hydrocracking and Hydroisomerization of N -Hexadecane, N -Octacosane and Fischer–Tropsch Wax over a Pt/SiO 2 –al 2 O 3 Catalyst

Catalytic cracking of n -decane over NiO–MoO 3 modified Pt/ZrO 2 –TiO 2 –Al 2 O 3 catalyst with different Al 2 O 3 ratios

Preparation and characterization of NiW-nHA composite catalyst for hydrocracking.

Combined Strategy and Ni NPs/SiO2 Aerogel Catalyst for Cracking Hydrocarbon Fuels