Abstract:During deformation of aluminum (Al) alloys, there are three kinds of voids being formed by distinct mechanisms, i.e., matrix-cracking voids (MCVs), particle-cracking voids (PCVs), and interface-debonding voids (IDVs), due to mesoscale heterogeneous deformation. The three kinds of void nucleation have different effects on the subsequent void growth, void coalescence, and ductile fracture of Al alloys. To determine the complex nucleation behavior of the three kinds of voids under mesoscale heterogeneous deformation, a microstructure- and damage-nucleation-based crystal plasticity finite element (MDNCPFE) model considering different nucleation mechanisms was established. To realize the MDN-CPFE modeling, the deformation and void nucleation of the matrix, particle, and their interface in Al alloys were described by a non-local dislocation density CP constitutive model and a local stored energy density criterion, an elastic constitutive model and a maximum principal stress criterion, and a cohesive zone model and fracture energy criterion, respectively. The developed MDN-CPFE model was validated by the nucleation locations and quantitative variations of the three kinds of voids in an in-situ tensile test. Using the developed model, the nucleation characteristics of the three kinds of voids during the small deformation of Al alloys were analyzed. It is found that PCVs are likely to nucleate within particles that are located at the deformation bands and with greater shape irregularity; IDVs are prone to nucleate at the interfaces around smaller particles in the deformation bands; MCVs tend to nucleate within grains with a higher Schmid factor and aspect ratio. The void area fractions (VAFs) of the three kinds of voids all evolve with an incubation stage and then followed by an exponentially increasing stage during deformation. The duration of the incubation stage for the three kinds of voids, designated by the nucleation strain, presents the following sequence: PCV < IDV < MCV; while, their VAFs and quantities present the opposite sequence. Additionally, the effects of the particle volume fraction and grain size on the nucleation strain, total VAF, and proportion of VAFs of the three kinds of voids were unraveled.

Molecular dynamics simulation on plasticity deformation mechanism and failure near void for magnesium alloy

Molecular dynamics simulation on plastic deformation and failure mechanisms around a crack tip for magnesium alloys

Microstructure- and Damage-Nucleation-based Crystal Plasticity Finite Element Modeling for the Nucleation of Multi-Type Voids During Plastic Deformation of Al Alloys

Atomistic Simulation Analysis of the Effects of Void Interaction on Void Growth and Coalescence in a Metallic System

Numerical simulation of plastic behavior and meso inhomogeneous deformation in AZ31 Mg alloy

Constitutive Modeling of Slip, Twinning and Detwinning for Mg Alloy and Inhomogeneous Evolution of Microstructure

Molecular Dynamics Simulation on Crack Propagation for Magnesium

Research Progress in Plastic Deformation Mechanism of M G Alloys Based on Molecular Dynamics

Atomic Simulation of Void Location Effect on the Void Growth in Nickel-Based Single Crystal

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

Molecular dynamics simulation of the effects of temperature on the microscopic deformation of single crystal magnesium containing a void and a crack

Molecular Dynamics Study on Interaction Between Voids for Pure Aluminum

Void Configuration-Induced Change in Microstructure and Deformation Mechanisms of Nano-Porous Materials

The effect of void defect on the evolution mechanisms of dislocations and mechanical properties in nickel-based superalloys by molecular dynamics simulation of real γ/γ′ structures

Deformation Analysis of Magnesium Alloy Based on Crystal Plasticity Theory

Molecular Dynamics Simulations of Pre-Crack Effects on Deformation and Failure Mechanisms for Pure Aluminum

Atomic Simulation of Mechanical Behavior of Mg in A Super-Lattice of Nanocrystalline Mg and Amorphous Mg-Al Alloy

Molecular dynamics simulation of impact on a high entropy alloy with void

Atomic Simulation of Interaction Mechanism Between Dislocation and Amorphous Phase in Dual-Phase Crystalline/amorphous Mg/MgAl Alloys

Constitutive Description for Casting Magnesium Alloy Involving Void Evolution

Crystal Plasticity Model and Simulations for Single Crystal Magnesium