Abstract:Owing to high heat flux ability and good mechanical strength, copper has been used for micro-electro-mechanical systems (MEMS) components with dimensions in micrometers processed by electrochemical methods. In the present study, fine grained copper foils of different thicknesses and grain sizes produced by pulsed electrodeposition under different controlled current densities were used to investigate the effect of total number of grains across thickness of foil on its tensile response and formability. For a comparative study, commercially available rolled Cu foils were also used. Vacuum annealing was employed to obtain a wide range of fully recrystallized grain sizes within same thickness of the foils. Detailed microstructural characterization was carried out using scanning electron microscope attached with electron backscattered diffraction detector. The foils were subjected to uniaxial tensile testing and formability testing using a miniaturized Nakazima test setup. As anticipated, finer the grain size higher was the yield strength. However, the strength of copper reduced with decreasing the total number of grains across thickness of the foil. The electrodeposited Cu foil exhibited relatively higher strength levels but reduced tensile ductility along with decreased strain hardening ability compared to the fully recrystallized Cu foils having similar grain sizes. Furthermore, the number of grains across thickness and the prior history of foils played significant role on the shape and trend in variation of the forming limit curve of Cu. An α-fiber (< 110 >) texture evolved in Cu during deformation and its volume fraction strengthened under biaxial deformation conditions.Graphical

Study on Texture of Electrolytic Copper Foil

Research Progress on the Texture of Electrolytic Copper Foils

Mechanical Properties and Microstructure of Rolled and Electrodeposited Thin Copper Foil

Effect of Cerium on Microstructure, Texture and Properties of Ultrahigh-Purity Copper

Relationship between the Orientation of the (100) Crystal Plane and Elongation in Ultrathin Electrolytic Copper Foils

Size Effect on Mechanical Properties and Texture of Pure Copper Foil by Cold Rolling

Processing and Specimen Thickness to Grain Size (t/d) Ratio Effects on Tensile Behaviour and Microformability of Copper Foils

Evolution of texture in electrodeposited Ni/Cu layered nanostructures

Microstructure and Texture Evolution in Cold-Rolled and Annealed Oxygen-Free Copper Sheets

Study on the relationship between crystal plane orientation and strength of electrolytic copper foil

XRD Study on Cu Layer in IC Interconnect

Trace Bis-(3-sulfopropyl)-disulfide Enhanced Electrodeposited Copper Foils

Effect of additives on the microstructure and properties of pulsed electrodeposited copper foils

Effects of microstructure and texture on the deep drawability of C10200 copper sheets

Surface morphology and crystal orientation of electrodeposited tungsten coatings with different pulse parameters

Anomalous vertical twins with high (2 2 0) texture in direct current electroplating copper film

The Overlooked Role of Copper Surface Texture in Electrodeposition of Lithium Revealed by Electron Backscatter Diffraction

Improvement of Thermal Conductivity of Electroplated Copper Thin-Film Interconnections by Controlling Their Micro Texture

Interpretation of texture changes during self-annealing of electroplated copper

Microstructure evolution in Cu-2.13Fe-0.026P (wt%): The contribution of texture intensity to residual stress variation