Abstract:An electroplating nickel bath is usually composed of a number of organic additives to improve the plating process as well as to preserve its durability. Supreme Plus Brightener (SPB) and A-5(2X), used in a commercial electroplating nickel bath show highly overlapped UV-Vis spectra. These two additives are the only ones that present absorbance in the UV-Vis wavelength range. Therefore, a mixture of them can be resolved using multivariate calibration methods of UV-Vis measurements. In this work, Partial Least Squares (PLS) regression and Classical Least Squares (CLS) have been used to quantify both additives during the whole duration of an electroplating nickel bath. It was found that PLS regression provided the best results. To avoid negative influence of baseline drifts, first derivative spectra were used. Between 0.14 and 1.40 mL of the commercial product SPB per L of nickel bath can be determined with mean errors of about 6%. Between 4 and 24 mL of the commercial product A-5(2X) per L of nickel bath can be determined with mean errors of about 8%. The limits of detection (LOD) found for SPB and A-5(2X) were 0.11 mL L−1 and 3 mL L−1 respectively. The calibration models proved to be valid for at least eight months, including a change of spectrophotometer. The SPB concentration decays along the bath life according to a first order rate law, but A-5(2X) remains unchanged. Independent brightness measurements showed that it was intimately related to the SPB concentration, in such a way that any of them can be deduced from the other one. This is of prime importance to keep the bath conditions under control.

Determination of Ni~(2+) in Zinc-Nickel Electroplating Solution by Direct Spectrophotometric Method

A Comparative Study Of Nickel(Ii) Removal From Electroplating Wastewater By Pre-Precipitation Combined With Fenton-Precipitation Or Fenton-Like-Precipitation

Experimental Research on Zn Ion Selective Electrode and Measurement of Minim Element

Determination and Identification of Nickel(II) Spectroscopy in Alloy Samples Using Chromogenic Reagent(HPEDN)

Electroplating Behavior of Zn-Ni Alloys in an Alkaline Electrolyte

[Uv-Vis Spectrometric Characterization of the Composition of Active Complex in the Ni-P Plating Solution].

Determination of Iron, Lead and Nickel in Zinc Powder by Atomic Absorption Spectrometry

Electroplating and Physicochemical Properties of Zinc–Nickel Alloy Coatings from Ammonium Oxalate Electrolytes

Determination of Trace Nickel(ΙΙ) Using a Kinetic Fluorescence Method with a Morin-Hydrogen Peroxide System

Detection of nickel ions in aqueous solution by laser induced fluorescence based on YZS70 resin

Determination of Ni,Al,P,Mg and Ca in Nickel Ores by Inductively Coupled Plasma-Atomic Emission Spectrometry

Effective Colorimetric Detection of Ni2+ Using Gold Nanoparticles Functionalized with Phytate

SIMULTANEOUS DETERMINATION OF COPPER AND NICKEL WITH DDTC SPECTROPHOTOMETRY IN THE PRESENCE OF TRITON X-100

Extending Silver Nanowire Modified Electrodes to Industrial Zinc Electrolyte for Copper Ion Detection

ZINC-NICKEL ALLOY ELECTROPLATING IN AN ALKALINE BATH

Nickel Speciation of Spent Electroless Nickel Plating Effluent along the Typical Sequential Treatment Scheme.

Quantitative determination of additives in a commercial electroplating nickel bath by spectrophotometry and multivariate analysis

Use of a new magnetic ion–imprinted nanocomposite adsorbent for selective and rapid preconcentration and determination of trace nickel by flame atomic absorption spectrometry

Electrochemical sensing platform based on Zeolite/Graphite/Dimethylglyoxime nanocomposite for highly selective and ultrasensitive determination of nickel

Amperometric Determination of Sulfide at a Pre-Oxidised Nickel Electrode in Acidic Media

Determination of Traces of Ni, Cu, and Zn in Wastewater and Alloy Samples by Flame-AAS after Ionic Liquid-Based Dispersive Liquid Phase Microextraction