Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

Analysis and Amelioration about the Cross-Sensitivity of A Fiber-Optic Accelerometer Based on Compliant Cylinder

Analysis and Amelioration about the Cross-Sensitivity of A High Resolution Moems Accelerometer Based on Diffraction Grating

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

Research On Accelerometer Based On Multi-Mode Interference

Determination of Thermally Induced Effects and Design Guidelines of Optomechanical Accelerometers

Study on a Fiber Bragg Grating Accelerometer Based on Push-Pull Compliant Cylinders

Research on an optimized optical fiber accelerometer for well logging

Design and Modification of a High-Resolution Optical Interferometer Accelerometer

An All-Fiberoptic Accelerometer Based on Compliant Cylinders

Analysis of the natural frequency and phase sensitivity of an optical fiber accelerometer coated with a rigid package

A Compliant Cylinder Fiber-Optic Accelerometer with Self-Mixing Technique

A Low Cross-Axis Sensitivity Micro-Grating Accelerometer With Double-Layer Cantilever Beams

Analysis of the Mechanics and Deformation Characteristics of Optical Fiber Acceleration Sensor

Analysis and Design for Piezoresistive Accelerometer Geometry Considering Sensitivity, Resonant Frequency and Cross-Axis Sensitivity

Frequency Response Optimization of Optical Fiber Acceleration Sensor Based on Compliant Cylinder

Fiber Optic Accelerometer Based on Fiber-Mirror Interference Cavity

Strain Distribution Characteristics of Sensing Fiber and Influence on Sensitivity of a Fiber-Optic Disk Accelerometer.

High Figure of Merit and Low Cross Sensitivity Fiber Bragg Grating Accelerometer Based on Double Grid-Diaphragms

Design, Simulation and Optimisation of a Fibre-optic 3D Accelerometer

Sensitivity Enhancement Method for Dual-Polarization Interferometric Fiber-Optic Angular Accelerometer