Abstract:In this study, a novel sol-gel method is used to synthesize amorphous silica-alumina materials with a narrow mesoporous distribution and various Si/Al molar ratios without using any templates and pore-regulating agents. During the preparation procedure, only inexpensive inorganic salts were used as raw materials, instead of expensive and harmful alkoxides. The precursor sol was dried at room temperature in a vacuum box kept at 60 mmHg until it began to form the gel. The results of a nitrogen sorption experiment indicate that the synthesized materials with different Si/Al molar ratios have similar mesoporous distributions (within 2-12 nm). Moreover, it was found that the material's pore size distribution remains at a similar value during the heat treatment from room temperature to 550 degreesC. On the basis of the nitrogen sorption, TEM, and AFM characterization results, a formation mechanism of mesopores which accounts for the experimental data is also suggested. This suggested mechanism involves rearrangement of the primary particles during the drying process to form the precursors of the similarly sized mesopores. The synthesized materials were characterized by XRD, thermal analysis (TG/DTA), Al-27 and Si-29 MAS NMR spectroscopy, SEM, TEM, and AFM. The results of Al-27 and 29Si MAS NMR indicate that the distribution of silicon and aluminum in the synthesized materials is more uniform and homogeneous than that in the mixed oxides prepared via the traditional sol-gel method even at high alumina contents. The type and density of the acid sites were studied using pyridine adsorption-desorption FTIR spectroscopy. It was shown that the acidity of the synthesized materials is higher than that of the silica-alumina materials prepared by conventional methods.

In-Situ Control of CaO-MgO-SiO2 Nanoparticles Synthesized by the Sol-Gel Method

Synthesis of a Porous Nano‐CaO/MgO‐Based CO2 Adsorbent

Synthesis, Characterization and Application of Submicron ZrSiO4 Powder Via Sol-Gel-microemulsion-hydrothermal Method

Controllable Synthesis of SiO2 Nanoparticles: Effects of Ammonia and Tetraethyl Orthosilicate Concentration

Sol–gel Synthesis and Sintering of Nano-Size Li2TiO3 Powder

Synthesis of Ag/SiO2 nanocomposite material by adsorption phase nanoreactor technique

Synthesis and microwave dielectric properties of (Ca0.7Mg0.3)SiO3 nanopowder prepared at low temperature

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Controllable Preparation of Sio2 Nanoparticles Using A Microfiltration Membrane Dispersion Microreactor

Preparation and Phase Formation Mechanism of CaSiO3 Doped with Mg/CaSiO3 by Sol-Gel Method

Synthesis and Microwave Dielectric Properties of CaSiO3 Nanopowder by the Sol–gel Process

Preparation and Properties of CaTiO_3:Zn Nanoparticles Based on Sol-Gel Method

pH control on preparation of nano-TiO_2 by gel-sol process

Synthesis and Microwave Dielectric Properties of CaO–MgO–SiO2 Submicron Powders Doped with Li2O–Bi2O3 by Sol–gel Method

Synthesis and Characterization of Ca3Co4O9 Nanoparticles by Citrate Sol-Gel Method

Particle Size Control in Sol-Gel Synthesis of Nano Hydroxyapatite

Size-controlled synthesis of nano α-alumina particles through the sol–gel method

A Novel Method To Synthesize Amorphous Silica−Alumina Materials with Mesoporous Distribution without Using Templates and Pore-Regulating Agents

Optimization of Nano-Meter TiO_2 Powders Preparation by Sol-Gel

Preparation of Highly Dispersed Precipitated Nanosilica in a Membrane Dispersion Microreactor

Ultrasonic Synthesis of Silica−Alumina Nanomaterials with Controlled Mesopore Distribution Without Using Surfactants