Abstract:The time-of-flight mass spectrometer (ToF-MS) is a useful tool for quantifying the performance of electrospray thrusters and characterizing their plumes. ToF-MS data can be used to calculate the mass-to-charge distribution in the plume, but the kinetic-energy-to-charge (i.e., the potential) distribution must be known first. Here we use a ToF-MS in tandem with a retarding potential (RP) analyzer. By sweeping the retarding potential through the range of potentials present in the plume, both the mass-to-charge distribution and the potential distribution can be measured independently. We demonstrate this technique in a case study using a capillary electrospray emitter and the ionic liquid propellant 1-Ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide, abbreviated EMI-Im. We report a linear correlation between retarding potential and mass-to-charge ratio that agrees with published data from more complex orthogonal RP/ToF-MS instruments. Calculated values for the jet velocity and jet breakup potential match within 2% and 12%, respectively. Using conventional ToF-MS, we estimated the propellant flow rate and compared those estimates to direct flow rate measurements. For flow rates between 233 pL/s and 565 pL/s, the error in ToF-based flow rate estimates ranged from -16% to -13% when the plume potential was assumed to be a function of mass-to-charge. Assuming a constant plume potential yielded mixed results. However, using the average stopping potential measured by a retarding potential analyzer resulted in higher errors, ranging from -26% to -30%. Data and MATLAB code are included as supplemental materials so that readers can easily apply the techniques described here. Supplementary information: The online version contains supplementary material available at 10.1007/s44205-023-00045-y.

Langmuir Probe Potential Measurements for Reduced-Pressure Inductively Coupled Plasma Mass Spectrometry

The ac-coupling between a Langmuir probe and a plasma and its effect on the plasma density measurement in the afterglow

Experimental Evaluation of Langmuir Probe Sheath Potential Coefficient on the HL-2A Tokamak

Determination of gas discharge plasma potential by Langmuir probe using different methods

Usage of displaced current in Langmuir probe measurement

Langmuir probe characteristics in a positive-ion/negative-ion plasma

Sampling of Plasma Plume from Atmosphere into Vacuum for Reliable Langmuir Probe Diagnostics

Electron density measurements in low-pressure plasmas using cutoff probes and comparison with hairpin and Langmuir probes

Langmuir Probe Diagnosis of a Cold Atmospheric Plasma Jet

Characterization of polyatomic ion interferences in inductively coupled plasma mass spectrometry using a high resolution mass spectrometer

Parametrization of electron sheath expansion for Langmuir probe I-V traces

Flush-Mounted Probe Diagnostics for Argon Glow Discharge Plasma

Potential Profile Measurements Inside a Gridded Cathode at High Potential in a Spherical Inertial Electrostatic Confinement Device

Langmuir Probe Diagnostics with Optical Emission Spectrometry (OES) for Coaxial Line Microwave Plasma

Comparative studies of cold/hot probe techniques for accurate plasma measurements

Improved analysis techniques for cylindrical and spherical double probes

Langmuir-probe measurement through the plasma grid aperture of hydrogen negative ion source

A simple retarding-potential time-of-flight mass spectrometer for electrospray propulsion diagnostics

Research on Low Pressure Electronic Density Diagnostic Method of Single Paperback Probe Based on Langmuir Probe Theory

Study of plasma parameters in high enthalpy ICP-heated wind tunnel by using single Langmuir probe

Double Flush-Mounted Probe Diagnostics and Data Analysis Technique for Argon Glow Discharge Plasma