Abstract:Ammonia is a well-known additive to promote crystal growth in hydrothermal synthesis of ZnO nanowires. Although the effect of ammonia on the nanowire growth has been intensively investigated, its influence on the seed layer, which governs the initial nanowire growth, is rarely discussed. Here, we demonstrate that ammonia strongly affects the seed layer as well as the following nanowire growth. On increasing the ammonia concentration, the nanowire density first increases and then decreases, while the nanowire growth rate keeps increasing. Experimental results and thermodynamic calculations of the initial growth process reveal that the transformation of the seed layer induced by ammonia prior to nucleation critically determines the nanowire density and thus also influences the following nanowire growth. Present results highlight the critical importance of discussing the variation of seed layers in ammonia-involved hydrothermal synthesis and suggest a novel seed engineering approach for tailoring the ZnO nanowire growth.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.jpcc.0c05490?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.jpcc.0c05490</a>.SEM images, diameter and areal density of ZnO nanowires grown with various seed layer thicknesses. The data was taken with a growth time of 3 h and without NH<sub>3</sub> (Figure S1); pH value and temperature of growth solution over time (Figure S2); EDS mapping analysis of the seed layer on a silicon substrate after immersing into growth solution with varying ammonia concentration for 10 and 30 min, respectively (Figure S3); thermodynamic calculation of Zn(II) solubility in aqueous solutions (S4); speciation of dissolved Zn(II) versus pH and temperature in growth solution (Figure S5) (<a class="ext-link" href="/doi/suppl/10.1021/acs.jpcc.0c05490/suppl_file/jp0c05490_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

The influence of aqueous ammonia on nano-ZnO

Effect of ammonia on morphology, wettability and photoresponse of ZnO nanorods grown by hydrothermal method

Effects of Electrodeposition Electrolyte Concentration on Microstructure, Optical Properties and Wettability of ZnO Nanorods

Conversion of large-scale oriented ZnO rod array into nanotube array under hydrothermal etching condition via one-step synthesis approach

Effect of solution concentration on surface morphology, optical properties and solar light response of ZnO thin films

Effect of Electrodeposition Time on Microstructure, Wettability and Optical Properties of ZnO Nanorod Arrays

Ammonia-Induced Seed Layer Transformations in a Hydrothermal Growth Process of Zinc Oxide Nanowires

Preparation, Characterization and Influential Parameters of Zno Nanoparticles Synthesized by Precipitation Method

Relation Between Zeta Potential and Dispersity in the Preparation Process of Nano-Scale Zno

Photocatalytic Degradation of Ammonia Nitrogen in Aquaculture Wastewater by Using Nano-ZnO

Growth and characterization of ZnO nanoflakes by hydrothermal method: effect of hexamine concentration

One-step growth of structured ZnO thin films by chemical bath deposition in aqueous ammonia solution

INFLUENCE OF AMMONIA ON THE NANOSTRUCTURES OF Ni NANO-FILMS

Relation between ζ Potential and Dispersity in the Preparation Process of Nano-scale ZnO

Hydrothermally Grown ZnO Nanostructures on the Different Substrates

The effect of process parameter on the synthesis yield of Ag/ZnO nano-composite antimicrobial

Structure Transformation of Hydrothermally Treated ZnO Nanorod Array

Effects of preparing conditions on the electrodeposition of well-aligned ZnO nanorod arrays

Preparation of ZnO nanoparticles using the direct precipitation method in a membrane dispersion micro-structured reactor

Growth and comparison of different morphologic ZnO nanorod arrays by a simple aqueous solution route

Influence of Temperature on the ZnO Nanostructures Surface Morphology and Optical Properties