Abstract:In this study, three different approaches, i.e. the sol-gel method, precipitation method and hard-template method, were applied to synthesize MgF2 catalysts with improved stability towards the dehydrofluorination of hydrofluorocarbons (HFCs); the in situ XRD technique was employed to investigate the relationship between the calcination temperature and the crystallite size of precursors to determine optimal calcination temperature for the preparation of the MgF2 catalysts. Moreover, the physicochemical properties of MgF2 catalysts were examined via BET, XRD, EDS and TPD of NH3 and compared. Undoubtedly, the application of different methods had a significant influence on the surface properties and catalytic performances of MgF2 catalysts. The surface areas of the catalysts prepared by the precipitation method, sol-gel method and template method were 120, 215 and 304 m2 g-1, respectively, upon calcination at 200 °C. However, the surface area of the MgF2 catalysts decreased significantly when the calcination temperatures of 300 and 350 °C were applied. The catalytic performance of these catalysts was evaluated via the dehydrofluorination of 1,1-difluoroethane (HFC-152a). The MgF2 catalyst prepared by the precipitation method showed the lowest catalytic activity among all the MgF2 catalysts. When the calcination temperature was above 300 °C, the MgF2 catalysts prepared via the template method demonstrated the highest catalytic conversion rate with catalytic activity following the order: MgF2-T (template method) > MgF2-S (sol-gel method) > MgF2-P (precipitation method). The conversion rate generally agreed with the total amount of acid on the surface of the catalysts, which was measured by the NH3-TPD technique. The MgF2-T catalysts were further examined for the dehydrofluorination of HFC-152a for 600 hours, and a conversion rate greater than 45% was maintained, demonstrating superior long-term stability of these catalysts.

Cr-Zn-Al Catalyst for Synthesizing HFC-134a by Gas Phase Fluorination

Overcoming the limitations of anthracene alkylation using SZ-DeAl-DFNS acid catalyst

A Mechanistic Study of the Hydrolysis of Tetrafluoromethane on Γ-Alumina

Highly Efficient C–F Bond Cleavage to Access Esters over Robust Silicon-Aluminum Phosphate Catalyst

Catalytic performance of alumina catalysts with different surface properties for the dehydrofluorination of HFC-134a (1,1,1,2-Tetrafluoroethane)

Synthesis of cis-1,3,3,3-tetrafluoropropene by catalytic isomerization of trans-1,3,3,3-tetrafluoropropene over alumina catalysts

Synthesis of 2,3,3,3-tetrafluoropropene by catalytic dehydrofluorination of 1,1,1,3,3-pentafluoropropane over Ni-Cr 2 O 3 catalyst

Sulfate ion induced formation of unsaturated coordination of AlF 3 nanocluster catalyst confined in carbon framework for catalytic dehydrofluorination

Atomic Layer Deposition of Pt Nanoparticles on Low Surface Area Zirconium Oxide for the Efficient Base-Free Oxidation of 5-Hydroxymethylfurfural to 2,5-Furandicarboxylic Acid

Zn-doped nano-Cr2O3 catalyst for fluorination of chlorinated light olefins

Preparation and characterization of chromium-doped magnesium fluoride catalysts via an aqueous sol–gel method

Rational design of MgF2 catalysts with long-term stability for the dehydrofluorination of 1,1-difluoroethane (HFC-152a)

Solution Combustion Synthesis of Cr₂O₃ Nanoparticles and the Catalytic Performance for Dehydrofluorination of 1,1,1,3,3-Pentafluoropropane to 1,3,3,3-Tetrafluoropropene

Fluorinated Cu/Zn/Al/Zr Hydrotalcites Derived Nanocatalysts for CO2 Hydrogenation to Methanol

A structural, mechanistic, and kinetic study of the dehydrofluorination of 1,1,1,3,3-pentafluoropropane in the absence of catalyst

Single-Atom Pt Catalyst for Effective C–F Bond Activation Via Hydrodefluorination

Catalytic hydrolysis of monochlorodifluoromethane over ZnO/ZrO2 catalysts at low temperatures

A fluorolytic sol-gel route to access an amorphous Zr fluoride catalyst: A useful tool for C-F bond activation

Efficient Selective Oxidation of 5-Hydroxymethylfurfural with Oxygen over a ZnCrAl Mixed Oxide Catalyst Derived from Hydrotalcite-like Precursor

Confined aluminum fluoride layers derived from the in situ etching of Ti3AlC2 as the robust catalyst for dehydrofluorination reaction

Modulating crystal phase of Zr-based solid acid catalyst to boost synthesis of 9, 9-bis(4-hydroxyphenyl) fluorene