Preparation and characterization of chromium-doped magnesium fluoride catalysts via an aqueous sol–gel method

Haodong Tang,Chaoyu Zou,Tao Hu,Nan Zhou,Yuzhen Li,Lichun Li,Wenfeng Han,Ying Li
DOI: https://doi.org/10.1007/s10971-019-05049-5
2019-06-19
Abstract:High surface area Cr3+-doped MgF2 catalysts were synthesized from an aqueous sol–gel method under mild conditions. The amount of Cr3+ doped in the investigated CrF3/MgF2 catalysts covered a wide range of mole concentration ranging from 0 to 25 mol% to reveal its effect on the properties of the catalysts. The physio-chemical properties of the CrF3/MgF2 catalyst were examined by means of N2 gas sorption, X-ray powder diffraction (XRD), energy dispersive spectrometer (EDS), and temperature-programmed desorption (TPD) of NH3. XRD analysis indicates that the doping of Cr3+ resulted in reduced crystallinity but did not change the original crystalline structure of MgF2. Doping of Cr3+ (8–25 mol%), on the other hand, can increase the surface area of CrF3/MgF2 significantly to ~300 m2/g from ~50 m2/g of the nondoped MgF2. There is also significant amount of Lewis acid sites formed upon incorporation of Cr3+ into MgF2 lattice, which was evidenced from the NH3-TPD results. The catalytic activity of the 25 mol% Cr3+-doped MgF2 catalyst on the dehydrofluorination reaction of 1,1-difluoroethane (HFC-152a, CH3CHF2) has reached a conversion rate of ~57%, which is over two times higher than the undoped MgF2 catalyst. Furthermore, the 25 mol% Cr3+-doped MgF2 catalyst has been successfully tested over 210 h upon the dehydrofluorination of CH3CHF2 at 300 °C with the conversion rate remain greater than ~45%.
materials science, ceramics
What problem does this paper attempt to address?