Abstract:Coating temperature is important for the coating reliability and reproducibility during the process of atmospheric plasma spray. A novel measurement and control approach for substrate and coating temperatures is presented. It is based on infrared (IR) pyrometry combined to specific robot spray trajectories in order to avoid harsh environment of spray workshops. The temperature evolution is continuously detected and recorded during preheating, spraying and cooling stages. The two specific factors, periodic average temperature and standard deviation were adopted to evaluate the temperature variation and the fluctuation of the thermal cycle relevant to one robot spray cycle based on the statistical method. These two factors are successful in describing the temperature variation during experimental processing sets. Finally, based on the monitoring system, the influence of Z-type robot spray trajectory parameters, including spray distance, scanning velocity and scanning step on coating temperature characterized by the two factors, is systemically investigated. Experimental results show that average temperature has no evident difference as a function of scanning velocity and no fixed relationship with scanning step, but just is dominated by the heating time of plasma jet and particle flux. Therefore, the selection of optimal scanning velocity just needs to take the temperature fluctuation into consideration. The temperature fluctuation decreases when scanning step increases, but both average temperature and fluctuation decrease with the increasing of spray distance and vice versa. Finally, on the basis of experimental results, a control experiment of sprayed coating temperature is presented to obtain constant temperature cycles by means of adjusting robot trajectories, cooling, among other considered operating parameters. Excellent control performance is observed.

An Integrated Investigation Approach for Coating Temperature Measurement and Control During Plasma Spraying

A Novel Integrated Temperature Investigation Approach of Sprayed Coatings During APS Process

Process Monitoring of Coating Temperature in Plasma Spraying

A Novel Intelligent Adaptive Temperature Control Approach of Sprayed Coating for APS Process

Influence of trajectory parameters on the coating temperature distribution in robotic plasma spraying

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

On-line Monitoring and Process Diagnosis of Coating Temperature in Plasma Spray

Experimental Research on Temperature Field of Plasma Spray Coating

Study On Temperature Field Measurement Of Plasma Stream During Rapid Sprayed Tooling

Plasma jet temperature field diagnostics for process control in rapid plasma spray tooling

Integrated Robotic Plasma Spraying System for Advanced Materials Processing

Temperature Field Analysis of Plasma-Sprayed Coatings for Thin-Wall Parts

Diagnosis of temperature of field of coating damage in plasma spray

Heat transfer characteristics of plasma spraying

On-line Detection and Process Control of Coating Thickness During Robotic Plasma Spraying

The Investigation of the Zirconium Silicate Coatings Prepared by APS

An Investigation of Particle Injection and Resulting In-Flight Particle Behavior During Air Plasma Spraying

Temperature measurements for Ni-Al and Ti-Al phase control in SHS Synthesis and plasma spray processes

Layer Structure Formation Induced by In-Situ Deposit Surface Temperature under Different Scanning Methods During Thermal Spraying

In-Flight Behaviors of Zro2 Particle in Plasma Spraying

Process Optimization of ZrO2 Thermal Barrier Coating by Plasma Spraying