Abstract:Coating temperature is important for the coating reliability and reproducibility during the process of atmospheric plasma spray. A novel measurement and control approach for substrate and coating temperatures is presented. It is based on infrared (IR) pyrometry combined to specific robot spray trajectories in order to avoid harsh environment of spray workshops. The temperature evolution is continuously detected and recorded during preheating, spraying and cooling stages. The two specific factors, periodic average temperature and standard deviation were adopted to evaluate the temperature variation and the fluctuation of the thermal cycle relevant to one robot spray cycle based on the statistical method. These two factors are successful in describing the temperature variation during experimental processing sets. Finally, based on the monitoring system, the influence of Z-type robot spray trajectory parameters, including spray distance, scanning velocity and scanning step on coating temperature characterized by the two factors, is systemically investigated. Experimental results show that average temperature has no evident difference as a function of scanning velocity and no fixed relationship with scanning step, but just is dominated by the heating time of plasma jet and particle flux. Therefore, the selection of optimal scanning velocity just needs to take the temperature fluctuation into consideration. The temperature fluctuation decreases when scanning step increases, but both average temperature and fluctuation decrease with the increasing of spray distance and vice versa. Finally, on the basis of experimental results, a control experiment of sprayed coating temperature is presented to obtain constant temperature cycles by means of adjusting robot trajectories, cooling, among other considered operating parameters. Excellent control performance is observed.

Plasma jet temperature field diagnostics for process control in rapid plasma spray tooling

Study On Temperature Field Measurement Of Plasma Stream During Rapid Sprayed Tooling

Advances in Thermal Plasma Temperature Diagnostic Methods

Measurement of Temperature Distribution in an Argon-Nitrogen Plasma Jet for Plasma Spray Rapid Tooling

Process Monitoring of Coating Temperature in Plasma Spraying

On-line Monitoring and Process Diagnosis of Coating Temperature in Plasma Spray

Plasma-Particle Interaction in Spray Forming

An Integrated Investigation Approach for Coating Temperature Measurement and Control During Plasma Spraying

A Novel Integrated Temperature Investigation Approach of Sprayed Coatings During APS Process

Integrated Robotic Plasma Spraying System for Advanced Materials Processing

An Investigation of Particle Injection and Resulting In-Flight Particle Behavior During Air Plasma Spraying

Numerical Analysis of In-Flight Behavior of Particle in Plasma Spray Forming

A Novel Intelligent Adaptive Temperature Control Approach of Sprayed Coating for APS Process

Experimental and Numerical Studies of Plasma Forming Process Parameters Effect on Optimum Particle Impact Locations

Numerical Analysis on Atmospheric Plasma Spray Process

Heat transfer characteristics of plasma spraying

Diagnosis of temperature of field of coating damage in plasma spray

Numerical Simulation of Temperature and Velocity Fields in Plasma Spray

Numerical Simulation of Coating Growth and Pore Formation in Rapid Plasma Spray Tooling

Retraction Of: In-Flight Analysis of Particles in Plasma Spraying

Heating Effect of Plasma Jet and Particle Flux in Plasma Spray