Abstract:With increasing trends in using municipal waste incineration (MWI) technologies, more consideration has been given to the problem of harmful byproducts in its flue. In 2014, a new national standard for pollution control of municipal solid waste incineration was released by the Chinese government, which also gives guidance to local governments to establish their own standards. In order to evaluate whether the treatment technologies for MWI flue gas can both meet the new standard and have overall positive environmental impacts across whole life cycle, a waste life cycle assessment (LCA) was conducted for flue gas to compare treatment technologies employed in MWI plants. Based on a case study of a plant in Changzhou China, a model was established using three combinations of technologies: (a) Spray semi dry reactor + activated carbon + filter bag (Scenario 1); (b) Spray semi dry reactor + dry deacidification reactor + activated carbon + filter bag (Scenario 2); (c) selective non-catalytic reduction (SNCR) + spray semi dry reactor + dry deacidification reactor + activated carbon + filter bag (Scenario 3). The study has wide policy implications on how the industry is, or should be, regulated. Normalized results revealed that technologies used in Scenarios 1 and 2 had less overall impacts on the environment and less direct impact from emissions than those of Scenario 3. Energy-conservation and emission reduction index showed that Scenario 2 best fits current conditions and policy goals about energy consumption and air pollutant emission, despite recent regulations for the requirement of including SNCR in incineration plants. The most significant limiting factor is NON, which is in alignment with the results of policy analysis. Integrated analysis showed that although Scenario 2 is the best choice under current circumstances, further improvement in technology are likely to meet with new standards. Policy-makers should comprehensively consider the environmental impacts of the entire life cycle instead of the one-size-fits all standard.(C) 2018 Elsevier Ltd. All rights reserved.

Experimental Study on New Drying/Incineration Process for Sludge Treatment

Pollutant removal of a new spray drying/incineration demanstration project with capacity of 600 t/d for sludge treatment

Feasibility analysis on drying and incineration of sewage sludge from a wastewater treatment plant

Study on the pollutants emission in sludge drying and incineration

The Performance and Environmental Impact of the Integrated Spray Drying and Incineration Demonstration Project for Dying Sludge Treatment

Drying Sewage Sludge Using Flue Gas from Power Plants in China

Atmospheric Emission Characterization of a Novel Sludge Drying and Co-Combustion System

Emission characteristics of sludge incineration in bubbling fluidized bed

Experimental study of sludge disposal in a large coal-fired power plant

Status and Development of Sludge Incineration in China

Sludge Drying Using Flue Gas and Its Role in Haze Source Control

Experimental research on thermal drying and combustion characteristics of sludge

New Thought on Treatment and Disposal of Sludge of Municipal Sewage Treatment Plants

Experimental Study on Hydrothermal Treatment of Municipal Sewage Sludge

Experimental Research of Pipe-Distributed MSW Fluidized Bed Incinerator

Review of sewage sludge treatment technology

Study On Sewage Sludge Fluidized Bed Incineration And Design Of 65t/D Incinerator

Evaluation of Flue-Gas Treatment Technologies for Municipal Waste Incineration: A Case Study in Changzhou, China

Disposal of Low Concentration Fume with Solid Waste Modified by Microwave.

Study on Desulfurization and Denitration of with Industry Solid Waste by Microwave

Two-stage low-temperature drying of sludge:Mechanisms and vapor/heat balance