Abstract:In this study, phosphogypsum (PG) is simulated by doping fluorine and phosphorus ions in pure dihydrate gypsum reagent and reveals the influence of fluorine and phosphorus impurities in PG on the crystal of α‐type hemihydrate gypsum. The research results provide an important reference for the future work in the purification stage of PG, and provides a new perspective for the study of impurities in the utilization of PG resources. In this study, phosphogypsum (PG) is simulated by doping fluorine and phosphorus ions in an analytically pure reagent of gypsum dihydrate. The influence of fluorine and phosphorus impurity and content on the dehydration reaction process of phosphogypsum and its crystalline micromorphology is assessed during the preparation of α‐type gypsum hemihydrate in the reversed‐phase microemulsion system and its mechanism. The results show that when the fluorine content increases from 0 to 1.0 mol L−1 (ωNaF = 1.0 mol L−1), the dehydration process of dihydrate gypsum will be greatly slowed down. Scanning electron microscopy (SEM) analysis showed that even a small amount of F− (ωNaF = 0.2 mol L−1) can significantly inhibit the formation of α‐type hemi‐hydrated gypsum. When ωH3PO4 = 0.10 mol L−1, the water of crystallization content in the solid phase of the sample decreased to 5.24% after 90 min, which is significantly lower than during the same period of the benchmark group. However, there is a threshold value for the effect of phosphorus on the microscopic morphology of the α‐type gypsum hemihydrate crystals, when ωH3PO4 ≤ 0.04 mol L−1, the crystal morphology is basically unaffected. Moreover, when ωH3PO4 continued to increase, the defects on the crystal surface increased.

Analysis of Particle Characteristics and Existing Formation of the Impurities in Wet FGD Gypsum

Study on the occurrence state of main components of phosphogypsum dihydrate and its impurity distribution

Study on Mechanisms for Improving Quality and Whiteness of Phosphogypsum Based on Process Mineralogy Analysis

Effects of the Impurities on the Habit of Gypsum in Wet-Process Phosphoric Acid

Effect of Fluorine and Phosphorus Impurities in Phosphogypsum on Microstructure and Mechanism of α‐Type Hemihydrate Gypsum Crystals

Analysis and Optimization of Chemical Processing Parameters for Wet Flue Gas Desulphurization System

Experimental Study and Mechanism Analysis of Preparation of α-Calcium Sulfate Hemihydrate from FGD Gypsum with Dynamic Method

Retarding effect of impurities on the transformation kinetics of FGD gypsum to α-calcium sulfate hemihydrate under atmospheric and hydrothermal conditions

Study on characteristics of organic components in condensable particulate matter before and after wet flue gas desulfurization system of coal-fired power plants

Phase transitions and phase diagrams of K and Cs overlayers on a reconstructed and unreconstructed Cu(110) surface.

Preparation of Anhydrite from Phosphogypsum: Influence of Phosphorus and Fluorine Impurities on the Performances

Insights into the Desulfurization Mechanism of Low-Grade Limestone As Absorbent Induced by Particle Size

A Novel Process to Recover Gypsum from Phosphogypsum

Comparative analysis of colloid-mechanical microenvironments on the efficient purification of phosphogypsum

Influence of crystal-transforming agent on the performance and mechanism of α-high-strength gypsum prepared from FGD gypsum

Study on performance and function mechanisms of whisker modified flue gas desulfurization (FGD) gypsum

Study of practice use of desulfurization gypsum

Study on Preparation of High-Strength Gypsum by FGD Gypsum

Review of the State of Impurity Occurrences and Impurity Removal Technology in Phosphogypsum