Abstract:Electrospinning is a manufacturing technique that can produce microfibers and nanofibers from polymeric solutions. It has a broad range of applications in areas such as tissue engineering, flexible electronics, filtering, etc. However, due to its chaotic behavior, the fibers obtained by this process are prone to high diameter variations. The high diameter variations will cause poor final product functionality. The diameter is affected by process variables, ambient conditions and in-situ measurements. It is therefore important to model their effect on the fiber diameter variation, which is rarely investigated in the literature. Towards this end, this paper systematically studies the electrospinning process of a biocompatible polymer (i.e., polyacrylonitrile (PAN) 10%) via experimental study and data-driven modeling. In particular, three critical process variables (i.e., voltage, tip-to-collector distance, and polymer flow rate), are varied in a central composite design of experiment. Twenty-four runs are executed for the data collection, during which the in-situ measurements are collected via a customized sensing system. After each experiment, scanning electron microscope (SEM) images are taken from the nonwoven mats and characterized to capture the diameter and the diameter variations. Three machine learning methods, Lasso, random forest (RF), and support vector machine (SVM), are applied to the collected data. The model performance is evaluated in the real case study on the electrospinning ofpolymeric solution. The most predictive model (RF) can yield an around 15% relative error for prediction in testing data on average over 100 replications.

Influence of processing parameters and drafting assembly design parameters on fiber diameter during spunbonding

Influence of Polypropylene (PP) Spunbonded Nonwovens Technics Parameter to Fiber Diameter

Testing of Spunbonded Polymer drafting assembly device of air jet flow field and test validation

Numerical simulation of jet flow field of flat narrow slot of drafting assembly in spunbonding process

Research progress in air drag of polymer spunbonding process and performance of hydroentangling jets

The Influence of Drawing Pressure on the Properties of Pet/Pa6 Bicomponent Spunbonded Fibers

Analyse and study on of jet flow field of the narrow slot passage of drafting assembly in spunbonding process

Effect of Air-Flow Parameters on the Morphology of Nanofibrous Yarns by Blown Bubble-Spinning

Research progress in air drag mechanism and air jet flow field of melt blowing process

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Analytical Modelling of Dry-Jet Wet Spinning

Isometric fiber distribution in the roller drafting zone

Numerical Study of Melt-Spinning Dynamic Parameters and Microstructure Development with Ongoing Crystallization

A Machine Learning Approach to Model the Electrospinning Process of Biocompatible Materials

Building of Spun-Bonded Nonwoven Drafting Device Injection Flow Field Theoretical Model

Effects of Six Processing Parameters on the Size of PCL Fibers Prepared by Melt Electrospinning Writing

Air Recirculation and Its Effect on Microfiber Spinning in Blunt-Die Melt Blowing

Experimental study and prediction of the diameter of melt-electrospinning polypropylene fiber

Effect of Die-Swell Ratio on Polyacrylonitrile As-Spun Fiber Formation

Spinning solution flow model in the nozzle and experimental study of nanofibers fabrication via high speed centrifugal spinning

Simulation and experimental study of parameters in centrifugal electrospinning: Effects of rotor form on fiber formation