Abstract:A blast furnace operates under a countercurrent flow process, and a wide variety of physical and chemical reactions take place, especially in the hearth at the highest temperature. Therefore, the working status and erosion of the carbon brick have a critical influence on the longevity of the blast furnace. Although the phenomena in the hearth cannot be directly observed through the black box, hearth dissection provides an alternative way to access and subsequently evaluate the internal conditions. In this paper, a 4000 m3 blast furnace hearth was dissected, and 12 residual iron samples were collected and subjected to composition, morphology, and thermal conductivity analyses. The results show that in the center of the hearth, the residual iron had thicker metallic iron strips. This is because the residual iron in the center of the dissected hearth was fully mixed with carbon or coke, and this mixing apparently enhanced the heat conductivity in the center of the hearth to as great as 80.5 W/(m K). However, such a mixing state was gradually relieved in the regions either close to the wall or settling on the bottom. Thus, the residual iron near the wall formed a needle-like surface with a layer-by-layer structure in the form of alternatively thinner strip-shaped carbon and metallic iron, and the thermal conductivities of the residual iron near the wall were above 40.0 W/(m K) regardless of the relative height. Moreover, the erosion mechanisms of the blast furnace hearth wall are proposed, and the erosion thickness is accordingly evaluated based on the heat transfer model, in which the measured thermal conductivities of the residual iron are taken into consideration. According to the erosion mechanism, the thickness of residual iron is thinner, the erosion is more serious.

Technological Measures for Prolonging Hearth Life of Blast Furnace

Development of long life technology of European blast furnaces

Numerical Simulation of Blast Furnace Hearth Maintenance Measures

Erosion Behavior and Longevity Technologies of Refractory Linings in Blast Furnaces for Ironmaking: A Review

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Technological countermeasures for low quality sinter and coke used in blast furnaces in JFE

Numerical Simulation Model for Evaluating Protection Measures of Blast Furnace Hearth

Thermofluid-Solid Coupling Numerical Simulation Model of Blast Furnace Hearth Protection Measures.

Influence of the Residual Iron on the Erosion of Carbon Bricks in a 4000 m3 Blast Furnace Hearth: From the Measured Properties to the Proposed Mechanisms

Migration Behavior of K, Na, S, Ti in Hearth of a Commercial Blast Furnace

Measurement of erosion state and refractory lining thickness of blast furnace hearth by using three-dimensional laser scanning method

Consideration of long campaign based on analysis of 4038 m3 blast-furnace hearth core investigation

Heat Transfer Evolution Process in Hearth Based on Blast Furnace Dissection

NEW DEVELOPMENT OF TECHNOLOGY FOR INCREASING COKE MIXED CHARGING RATIO IN BLAST FURNACE

Calculation on effective heat of injected pulverized coal in blast furnace

Occurrence State and Behavior of Carbon Brick Brittle in a Large Dissected Blast Furnace Hearth

Numerical Analysis on Erosion and Optimization of a Blast Furnace Main Trough

Analysis of the Relationship between Productivity and Hearth Wall Temperature of a Commercial Blast Furnace and Model Prediction

Investigation of the Hearth Erosion of WISCO No. 1 Blast Furnace Based on the Numerical Analysis of Iron Flow and Heat Transfer in the Hearth

DEVELOPMENT OF SHORT-TERM INSPECTION TECHNOLOGY FOR BLAST FURNACE

Development of stabilization measures aimed at removing zinc with smelting products and accumulating titanium in the hearth of a blast furnace