Abstract:Polyethylene Terephthalate (PET) is a polar polymer and is best known as the material that constitutes a soft drink bottle. PET has excellent physical properties, such as, high heat resistance, low cold resistance, solvent resistance, and so on. It is also used as an electrical insulation or a dielectric material. In previous studies of Seki et al.(2014), in stepwise method to increase the AC electric field, the simultaneous observations of the dissipation current waveforms and electroluminescence (EL) for polar polymeric film PET and nonpolar polymeric film LDPE were carried out. From the results of observations, it was found that the nonlinear dissipation current waveform on PET at 50 Hz shows not only the large peaks at the former part of positive and negative half cycle, but also the small peaks at the latter part, and the hysteresis curve of the instantaneous current density J versus the instantaneous electric field E showed the hysteresis. Furthermore, the electric field dependence of the power loss density estimated from the hysteresis curve above the electric field of 26 kV/mm at the frequency of 50 Hz was shown the trend of saturation. In order to control the electric field application history condition, the simultaneous observations under AC ramp voltage application had been developed. Here, the time for observation was set for 10 s to make an electric field application condition same. There is another advantage. The short time electric field application makes possible to apply the further higher electric field, because the risk of occurrence of PD and/or breakdown are reduced. In this study, by using the AC ramp voltage application method, the simultaneous observations up to 60 kV/mm were carried out for both PET and LDPE samples in order to grab the conduction mechanisms of polar polymer.

The Study on Electroluminescence and Current Characters of PET Films under High Dc Fields

Experimental Study of Low-Voltage -Driven Thin Film Electroluminescence Mechanism

Experimental study of excitation efficiency distribution in low-voltage-driven thin film electroluminescent devices

High-field dielectric property of PET film under AC ramp voltage application

Study on Electroluminescence Phenomena from Ptfe under Hvac

Influence of High Frequency Ex-electric Field on Etching Process and Shape of Pores for Nuclear Track Film

Electroluminescence Performance Optimization of Films based on the Change of Macroscopic Structure and Microscopic Calculation

Low Field-Induced Electron Emission Phenomenon Observed from the Carbon Containing Thin Films

Modification of Amorphous Poly(ethylene Terephthalate) Surface by UV Light and Plasma for Fabrication of an Electrophoresis Chip with an Integrated Gold Microelectrode

Field Electron Emission from Carbon Containing Thin Films

All carbon nanotube based flexible field emission devices prepared through a film transfer method

Field-dependent properties of electroluminescent devices based on DCM-doped poly(p-phenylene vinylene) derivatives

Properties of PET/ITO Thin Films Deposited by DC Magnetron Sputtering

Plasma enhancement of current from carbon cathodes for field emission displays

Electric Field Evolution of Charge and Energy Transfer in Molecule-Doped Polymer Light-Emitting Diodes

Performance Study Of Field Emission Backlight Unit And Display

Field Emission Characteristics of Polymethyl Methacrylate Polymer Thin Film

Opto-impedance spectroscopy and equivalent circuit analyses of AC powder electroluminescent devices

Field-Emission Energy Distribution of Carbon Nanotube Film and Single Tube under High Current

Surface Electroluminescence Phenomena from Polymer under AC Voltage

Electroluminescence and Surface Trap Distribution in Polymeric Insulation