Abstract:Purpose: X-ray fluorescence computed tomography (XFCT) is an emerging molecular imaging modality for preclinical and clinical applications with high atomic number contrast agents. XFCT allows detection of molecular biomarkers at tissue depths of 4-9 mm at L-shell energies and several centimeters for K-shell energies, while maintaining high spatial resolution. This is typically not possible for other molecular imaging modalities. The purpose of this study is to demonstrate XFCT imaging with reduced acquisition times. To accomplish this, x-ray focusing polycapillary optics are utilized to simultaneously increase x-ray fluence rate and spatial resolution in L-shell XFCT imaging. Materials and methods: A prototype imaging system using a polycapillary focusing optic was demonstrated. The optic, which was custom-designed for this prototype, provided a high fluence rate with a focal spot size of 2.6 mm at a source to isocenter distance of 3 cm with a ten times higher fluence rate compared to standard collimation. The study evaluates three different phantoms to explore different trade-offs and limitations of L-shell XFCT imaging. A low-contrast gold phantom and a high-contrast gold phantom, each with three target regions with gold concentrations of 60, 80, and 100 μg ml - 1 for low contrast and 200, 600, and 1000 μg ml - 1 for high contrast, and a mouse-sized water phantom with gold concentrations between 300 and 500 μg ml - 1 were imaged. X-ray fluorescence photons were measured using a silicon drift detector (SDD) with an energy resolution of 180 eV FWHM at an x-ray energy of 11 keV. Images were reconstructed with an iterative image reconstruction algorithm and analyzed for contrast to noise ratio (CNR) and signal to noise ratio (SNR). Results: The XFCT data acquisition could be reduced from 17 h to under 1 h. The polycapillary x-ray optic increases the x-ray fluence rate and lowers the amount of background scatter which leads to reduced imaging time and improved sensitivity. The quantitative analysis of the reconstructed images validates that concentrations of 60 μg ml - 1 of gold can be visualized with L-shell XFCT imaging. For a mouse-sized phantom, a concentration of 300 μg ml - 1 gold was detected within a 66 min measurement. Conclusions: With a high fluence rate pencil beam from a polycapillary x-ray source, a reduction in signal integration time is achieved. It is presented that subtle amounts of contrast agents can be detected with L-shell XFCT within biologically relevant time frames. Our basic measurements show that the polycapillary x-ray source technology is appropriate to realize preclinical L-shell XFCT imaging. The integration of more SDDs into the system will lower the dose and increase the sensitivity.

Development and Application of Glancing Incident X-Ray Fluorescence Spectrometry Using Parallel Polycapillary X-Ray Lens

Grating-Based X-Ray Phase Contrast Imaging With a Polycapillary Semilens

Multispectral Large-Panel X-ray Imaging Enabled by Stacked Metal Halide Scintillators

A Time-Resolved Three-Channel Soft X-ray Spectrometer

Application of a Monolithic Polycapillary X-ray Lens in EXAFS Experiments

A new compact micro‐XRF spectrometer with polychromatic x‐ray sample excitation

Application Of Monolithic Capillary Half Focusing X-Ray Lens In Micro-Exafs Analytical Technology

Full-field Fan-Beam X-Ray Fluorescence Computed Tomography System Design with Linear-Array Detectors and Pinhole Collimation: a Rapid Monte Carlo Study

Timepix3-based Single Layer X-ray Fluorescence Compton Camera

Experimental Demonstration of X-Ray Fluorescence CT Using a Spatially Distributed Multi-Beam X-Ray Source

Synchrotron-based X-ray Fluorescence Ghost Imaging

Characterization of a Confocal Three-Dimensional Micro X-ray Fluorescence Facility Based on Polycapillary X-ray Optics and Kirkpatrick–Baez Mirrors

X-ray Fluorescence Compton Imaging Technique Based on a Single-layer Timepix3 Photon-counting Detector

Laboratory X-Ray Spectrometer for XAFS Measurements

Simultaneous X-Ray Fluorescence and K-edge CT Imaging with Photon-Counting Detectors

Snr Analysis of Polychromatic Fan-Beam Xfct System Using A Czt Detector Array

Laboratory-based micro-X-ray fluorescence setup using a von Hamos crystal spectrometer and a focused beam X-ray tube

PIXE-induced XRF with Transmission Geometry

Quasi-parallel X-ray microbeam obtained using a parabolic monocapillary X-ray lens with an embedded square-shaped lead occluder

Grating-Based X-Ray Phase Contrast Imaging Using Polychromatic Laboratory Sources

Reduced acquisition time for L-shell x-ray fluorescence computed tomography using polycapillary x-ray optics