Abstract:This study employs the finite element (FE) method to analyze the Incremental Sheet Forming (ISF) process of Ti-6Al-4V titanium alloy. The numerical modeling of pressure-assisted warm forming of Ti-6Al-4V sheets with combined oil-heating and friction stir rotation-assisted heating of the workpiece is presented in this article. The thermo-mechanical FE-based numerical model took into account the characteristics of the mechanical properties of the sheet along with the temperature. The experimental conditions were replicated in FEM simulations conducted in Abaqus/Explicit, which incorporated boundary conditions and evaluated various mesh sizes for enhanced accuracy and efficiency. The simulation outcomes were compared with actual experimental results to validate the FE-based model's predictive capacity. The maximum temperature of the tool measured using infrared camera was approximately 326 °C. Different mesh sizes were considered. The results of FEM modeling were experimentally validated based on axial forming force and thickness distribution measured using the ARGUS optical measuring system for non-contact acquisition of deformations. The greatest agreement between FEM results and the experimental result of the axial component of forming force was obtained for finite elements with a size of 1 mm. The maximum values of the axial component of forming force determined experimentally and numerically differ by approximately 8%. The variations of the forming force components and thickness distribution predicted by FEM are in good agreement with experimental measurements. The numerical model overestimated the wall thickness with an error of approximately 5%. By focusing on the heating techniques applied to Ti-6Al-4V titanium alloy sheet, this comparative analysis underlines the adaptability and precision of numerical analysis applied in modeling advanced manufacturing processes.

Finite Element Simulation on the Deep Drawing of Titanium Thin-Walled Surface Part

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Modeling and simulation of die forging process for large-scale titanium alloy forging

Finite Element Simulation of Bending Thin-Walled Parts and Optimization of Cutting Parameters

Finite Element Simulation of Extrusion Process of TC4 Titanium Alloy Profile

A New Fe Modeling Method for Isothermal Local Loading Process of Large-Scale Complex Titanium Alloy Components Based on Deform-3d

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

Numerical Analysis Of Formability Of Stepped Cup In Non-Isothermal Deep Drawing Of Aluminum Alloy Sheet

3D FEM simulation of isothermal forging process for TC11 titanium alloy impeller

Study on Micro Deep Drawing Process and Die Design

Finite element analysis on stamping car cradle with local thickening

Numerical and Physics Simulations of Variable Blank Holder Force in Process of Deep Drawing Complex Overlay

Optimization of Process Parameters in Deep Drawing Process Based on Orthogonal Experiment Method

Thermo-Mechanical Numerical Simulation of Friction Stir Rotation-Assisted Single Point Incremental Forming of Commercially Pure Titanium Sheets

Reaearch of finite element modeling & experiment of the die structure for high-strength steel sheet metal stamping

Simulation and Microstructural Analysis of Twin-Induced Plasticity Steel Cylinder Deep Drawing

Advanced FEM Insights into Pressure-Assisted Warm Single-Point Incremental Forming of Ti-6Al-4V Titanium Alloy Sheet Metal

Enhancing formability in deep drawing: A 3D finite element analysis of plastic wrinkling in AA2090 Al–Li alloy

Effect of process parameters on the deep drawing formability of aluminum and advanced high-strength steel square cups