Abstract:In this study, we designed and experimentally evaluated a series-connected array of superconductor-insulator-superconductor (SIS) junctions in the 100-GHz band mixer for the multi-beam receiver FOREST on the Nobeyama 45-m millimeter-wave telescope. The construction of the junction chip comprised a waveguide probe antenna, impedance matching circuit, SIS array junction, and choke filter, which were made from a superconducting niobium planar circuit on a quartz substrate. The multi-stage impedance matching circuit between the feed point and the SIS junction was designed as a capacitively loaded transmission line, and it comprised two sections with high (~90 Ohm) and low (~10 Ohm) characteristic impedance transmission lines. The structure of this tuning line was simple and easy to fabricate, and the feed impedance matched with the SIS junction in a wide frequency range. The signal coupling efficiency was more than 92% and the expected receiver noise temperature was approximately two times the quantum limit for 75-125 GHz based on quantum theory. The array junction devices with 3-6 connected junctions were fabricated and we measured their performance in terms of the receiver noise temperature and gain compression in the laboratory. We successfully developed an array junction device with a receiver noise temperature of ~15-30 K and confirmed that the improvement in the saturation power corresponded to the number of junctions. The newly developed array junction mixer was installed in the FOREST receiver and it successfully detected the 12CO (J = 1-0) molecular line toward IRC+10216 with the Nobeyama 45-m telescope.

SUBMILLMETER-WAVE DIRECT DETECTORS WITH Nb-BASED SUPERCONDUCTING TUNNEL JUNCTIONS

Ultra-broadband Microfiber-Coupled Superconducting Single-Photon Detector

Microfiber-coupled superconducting nanowire single-photon detector for near-infrared wavelengths.

Terahertz high-sensitivity SIS mixer based on Nb-AlN-NbN hybrid superconducting tunnel junctions

Integration of semiconductor readout circuits and superconductor THz detectors

Wideband frequency metrology using high temperature superconducting Josephson junctions

Terahertz Direct Detectors Based on Superconducting Hot Electron Bolometers with Different Biasing Methods

Sensitivity of High Temperature Superconducting Josephson Detectors at Millimetre-Wave Band

Terahertz Detectors Based on Superconducting Hot Electron Bolometers

High Efficiency, Large-Active-area Superconducting Nanowire Single-Photon Detectors

A liquid nitrogen cooled superconducting transition edge sensor with ultra-high responsivity and GHz operation speeds

An efficient coupling structure for THz detectors array

Bowtie Loaded Meander Antenna for a High-Temperature Superconducting Terahertz Detector and Its Characterization by the Josephson Effect

Single Photon Detectors Based on Superconducting Nanowires over Large Active Areas

Cascade switching current detectors based on arrays of Josephson junctions

Design Of Planar Antennas For The Superconducting Terahertz Detector

Mid-infrared characterization of NbTiN superconducting nanowire single-photon detectors on silicon-on-insulator

Terahertz Emission and Detection Both Based on High-Tc Superconductors: Towards an Integrated Receiver

Supercontinuum Single-Photon Detector Using Multilayer Superconducting Nanowires

Series-connected array of superconductor-insulator-superconductor junctions in the 100-GHz band heterodyne mixer for FOREST on the Nobeyama 45-m telescope

Theoretical Simulation of the Mixing Performance of Distributed Superconducting Tunnel Junction Arrays at 1.3 THz