Abstract:This study aims at establishing a model for close-contact melting (CCM) of shear-thinning fluids. We presented a theoretical framework for predicting the variation of liquid melt film thickness and motion of unmelted solid for both Carreau and power-law fluids. We identified the appropriate energy equation considering the convective effect and derived an analytical temperature profile across the liquid film. Using the lubrication approximation, force equilibrium relationships and the corresponding numerical approaches were built. By using laser interferometry and photographic recording methods, we found excellent agreement between numerical solutions and experimental results for Carreau liquids, revealing that the convective effect weakens heat transfer and melting rate. We identified the critical liquid film thickness that determines three situations of CCM in the theoretical model for Carreau fluids. Numerical prediction demonstrated that the CCM of Carreau fluids can be almost equivalent to that of power-law fluids if the initial film thickness is greater than the critical value. Finally, approximate analytical models were developed for both Carreau and power-law models. For the applicability of the approximate analytical solutions, we derived two-and three-dimensional dimensionless phase diagrams of validity range and identified a key dimensionless group (?Re)Re-4/3 [3 ln(Ste + 1)](1/3) Pe(-1/3), where ? is dimensionless characteristic time, Re is Reynolds number, Ste is Stefan number and Pe is Peclect number. The reliability of the approximate solutions was verified by comparing with the numerical results. These approximate solutions enable convenient and low-cost computational prediction of the dynamic CCM process of shear-thinning fluids.

Study on Lubricant Thermal Influence on Flow Factors

On Elastic Deformation, Inter-Asperity Cavitation and Lubricant Thermal Effects on Flow Factors

A Thermal Equilibrium Analysis of Line Contact Hydrodynamic Lubrication Considering the Influences of Reynolds Number, Load and Temperature

Numerical simulation of flow and heat transfer in journal bearing lubrication

Close-contact Melting of Shear-Thinning Fluids

Influence of Inter-asperity Cavitation of Rough Surfaces on Flow Factors

Study on Combined Influence of Inter-Asperity Cavitation and Elastic Deformation of Non-Gaussian Surfaces on Flow Factors

Some Aspects of Determining the Flow Factors

Friction Factor And Heat Transfer Of Nanofluids Containing Cylindrical Nanoparticles In Laminar Pipe Flow

Thermal Analysis of Lubricated Three-Dimensional Contact Bodies Considering Interface Roughness

Numerical Analysis on the Effect of Transverse Surface Roughness in Non-Newtonian Fluid Lubrication

Analysis of the Effect of Surface Topography on Lubrication Using Heterogeneous Multiscale Method

Effects of Roughness on Fluid Flow Behavior in Ducts

Experimental Study of Flow Characteristics in Rough Microchannels

Numerical Analysis on the Factors Affecting the Hydrodynamic Performance for the Parallel Surfaces with Microtextures

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Coupled nonlinear effects of random surface roughness and rarefaction on slip flow in ultra-thin film gas bearing lubrication

The Influence of Elastic Deformation of Rough Surfaces on the Flow Factor

Slip Flow and Thermal Characteristics in Gas Thrust Bearings with Rough Surfaces

Numerical Analysis on Effect of Regular Surface Topography in Non-Newtonian Fluid Lubrication

ROUGHNESS AND RAREFACTION EFFECTS ON FLOW CHARACTERISTICS IN MICROCHANNELS