Synthesis Of Beta-Sialon-Aln-Polytypoid Ceramics From Aluminum Dross

Jiajing Li,Jun Wang,Haiyan Chen,Baode Sun,Junbiao Jia
DOI: https://doi.org/10.2320/matertrans.MH200913
2010-01-01
MATERIALS TRANSACTIONS
Abstract:Aluminum dross is one of the main secondary wastes during aluminum recycling procedure. It is utilized to synthesize beta-SiAlON-AlN-polytypoid ceramics by the reduction-nitridation method in this paper. The effects of the reaction parameters, such as the Si/Al ratio, reaction temperature and holding time are studied in detail. The results indicate that the synthesized products are mainly composed of beta-SiAlON and Mg-AlN-polytypoid at 1450 degrees C to 1650 degrees C for 6 h. As the Si/Al ratio changes from 1.0 to 2.5, the amount of beta-SiAlON increases while the amount of Mg-AlN-polytypoid decreases. At 1750 degrees C, the samples consist mainly of AlN and AlN-polytypoid because SiO gas is significantly evaporated. With the increment of synthesis temperature, the growth of elongated Mg-AlN-polytypoid grains is significantly accelerated. SEM and EDS analysis results for the samples formed at 1650 degrees C for 6h show that the beta-SiAlON grains display a short platelet morphology, and Mg-AlN-polytypoid grains possess needle or lath morphology. This study suggests that it is possible to synthesize the low cost SiAlON ceramics with high toughness from aluminum dross. [doi:10.2320/matertrans.MH200913]
What problem does this paper attempt to address?