Abstract:Compared with traditional liquid and solid processing methods, semi-solid die casting process can apparently overcome shrinkage cavity and porosity defects in castings and high deformation resistance and high residual stress shortcomings in forging parts. Semi-solid die casting process with advantages such as high efficiency and low cost, will become the optimal process for high quality automobile parts. In this study, using the clamp as an example, the author introduced product structure optimization and die design for semi-solid die-casting process of aluminum alloy in a new product development.The Computer Aided Engineering technology was applied to the product structure optimization according to the stress analysis. The optimal mold structure, including cavity layout, gating system, overflow and vent systems, were confirmed based on the die design criteria for traditional die casting, combining with the characteristics of semi-solid forming and the simulation results. The semi-solid aluminum alloy clamp parts with excellent performances were finally developed successfully by means of product structure optimization, die design, parameters optimization of die casting process, and the mechanical properties test of products.The existing parts were optimized to make them more suitable for semi-solid die casting processing. In addition, a reasonable die design specially for semi solid processing was an important guarantee for a successful semi solid product applied in industry. Computer numerical simulation was applied in product structure design for semi-solid die casting, die design, die-casting process optimization and other aspects, to shorten the development cycle of new product, reduce cost and improve efficiency.

Die Casting Semi-Solid ZL101 Alloy Prepared by Inclined Slope Cooling-Transferring Method and its Properties

Research on the constitutive relationship of semi-solid ZL201 alloy

Microstructure and Mechanical Properties of Semi-Solid Die Casting Mg–5Zn–2Gd–0.6Zr Alloy

Semisolid Die-Casting Process of Mg-20Al-0.8Zn Magnesium Alloy

Effect of Solutionising and Ageing on the Microstructure and Mechanical Properties of a High Strength Die-Cast Al–Mg–Zn–Si Alloy

Study on a Semi-Solid Rheo-Diecasting Process With AZ91D Alloy Slurry

Effects of Temperature and Holding Time on the Semi-Solid Isothermal Heat-Treated Microstructure of ZL104 Aluminum Alloy

Enhanced strength-ductility synergy in a rheo-diecasting semi-solid aluminum alloy

Microstructure and Mechanical Properties of Magnesium Alloy AZ91D Produced by Rheo-Diecasting Process

Solidification behavior and enhanced properties of semi-solid Al–8Si–0.5Fe alloys fabricated by rheo-diecasting

Performance of semi-solid slurry produced by twin-screw stirring mixer and rheo-diecasting process of AZ91D alloy

Preparation of semisolid A356 alloy by a cooling slope processing

Numerical Simulation and Experimental Study on Semi-solid Forming Process of 319s Aluminum Alloy Test Bar

Influence Of Solidification Parameters On The Microstructure And Properties Of Dz125 Superalloy Castings

Numerical Simulation of Semi-Solid Die Casting of ZA Alloy Automotive Bushing Based on AnyCasting

The Effect of Initial Microstructure of A356 Alloys on the Mechanical Behavior in the Semisolid State

Microstructure and Properties of Mg-5Al-1.5Ca-0.4Zn Based Alloyby Semi-Solid Isothermal Heat-Treatment-die-pressure-casting Process

Development of Semi-Solid Die Casting Process Technology for Aluminium Alloy Clamp

Study on Semisolid Rheo-Diecasting Process, Microstructure and Mechanical Properties of Mg-6Al-1Ca-0.5Sb Alloy with High Solid Fraction

Effect of Semi-Solid Isothermal Heat Treatment on Microstructure of Zl104 Aluminum Alloy

Al–5.5Mg–1.5Li–0.5Zn–0.07Sc–0.07Zr alloy produced by gravity casting and heat treatment processing