Abstract:Electrochemical deposition (ED) has been proposed as a low temperature approach for preparing hydroxyapatite (HA) coatings. To overcome the problem of low adhesion, the preparation of thin and low-porosity coatings on Ti substrates pre-treated by micro-arc oxidation (MAO) is a good strategy. In this paper, a thin and dense HA coating was obtained by modifying parameters at pH 6.4, 45 °C, and 0.5 mA·cm −2 . The growth behaviours of HA electrodeposited on MAO coatings were investigated by SEM and EDS technology and summarized that the HA was initially generated in the MAO micropores, then covered the entire MAO surface and gradually grew outwards. This growth pattern was also confirmed by ATR-FTIR, XPS, EIS, open potential, and wettability results at different ED cycles. Adjusting 1:1 power-on/off time ratio affected the morphology of HA grown in the pores in the early stage and also increased the interfacial strength, up to 10.69 MPa at duty cycle 12/24.The cross-section of the final specimen was characterised by TEM and EDS, indicating that amorphous layers, nanocrystalline HA, and submicron HA were formed sequentially from the TiO 2 (Ca)/HA interface outwards. The increase in Ca 2+ concentration and the formation of CaO bonds at the interface may be important reasons for the adhesive enhancement. This process provides a strategy to enhance the strength of bioceramic materials on Ti substrates.

Development of nano-hydroxyapatite coating by electrohydrodynamic atomization spraying

Preparation of hydroxyapatite coating on smooth implant surface by electrodeposition

Electrolytic Deposition of Hydroxyapatite Coating on CoNiCrMo Substrates

A Novel Method to Synthesize Hydroxyapatite Coating with Hierarchical Structure

Electrodeposition of Hydroxyapatite Coating on CoNiCrMo Substrate in Dilute Solution

Synthesis and Characterization of Zn-substituted Hydroxyapatite Coatings by Electrochemical Deposition

Synthesis and Charaterization of Silicon-Substituted Hydroxyapatite Coating by Electrochemical Deposition on Ti Substrate

Effect of EDTA on Electrodeposition of Hydroxyapatite Coatings

An electrically driven jetting technique for diverse high-resolution surface structures of nanometre hydroxyapatite crystals.

Development of Template-Assisted Electrohydrodynamic Atomization Spraying for Nanoha Patterning

Electrohydrodynamic Coating of Metal with Nano-Sized Hydroxyapatite.

Evolution of the magnesium incorporated amorphous calcium phosphate to nano-crystallized hydroxyapatite in alkaline solution

Electrospray deposition of nanohydroxyapatite coatings: A strategy to mimic bone apatite mineral

Effect of Heat Treatment of Nano-Hydroxyapatite Coatings Prepared Using Electrohydrodynamic Deposition

Processing and in vitro behavior of hydroxyapatite coatings prepared by electrostatic spray assisted vapor deposition method

Preparation and growth behaviours of low porosity hydroxyapatite with enhanced adhesion by electrochemical deposition on micro-arc oxide coatings

A novel jet-based nano-hydroxyapatite patterning technique for osteoblast guidance.

Generation of Biomaterial Particles with Controlled Dimensions Via Electrospraying

Preparation and biological evaluation of Nano-HA coating on tatinium surfaces

EHDA Spraying: A Multi-Material Nano-Engineering Route.

Recent advances in multifunctional hydroxyapatite coating by electrochemical deposition