Abstract:Experimental investigations of dynamic characteristics of the check valve are a contribution work to provide boundary condition to check valve mathematical simulation. The closure process of the check valve was tested. The changing processes of inlet and outlet pressure were performed. Based on the experiment system and the measured quantities, mathematical models were established to study the test. Numerical calculation was mainly focus on when valve starting to close and the closing characteristic time. The paper simulated the different minimum velocities that the valve started to close at. Simulation results approximated to test data when the check valve started to close at a larger flow velocity and a shorter closing characteristic time. The closing characteristic time was discussed when check valves closing on a certain velocity. Following the closure rule of check valve got during the simulation, the paper studied the check valve acting on a long distance pumping system. Two part contents were studied: only check valve arranged along pipeline, both air admission valve and check valves arranged. Along the pipeline seven check valves were arranged, the pump power failure condition was calculated and check valves were closed because of the flow velocity decreased The result showed negative pressure was large when installed just a finite number of check valves along pipeline. Gas admission valves were arranged to negative pressure prevention. Two check valves were respectively arranged at the pump outlet and pipeline. The pressure transient peak at pump outlet will be dropped a lot with the check valve at pipeline closed; the maximum pressure transient peak along pipeline is appeared at check valve outlet on the pipeline under the pump power failure condition. The negative pressure in front pipes could be prevented by installing gas admission valve. Through the check valves and gas admission valves combined action, both the pressure and backflow were well controlled.

Optimization of Closing Ways of Slow Closing Check Valve by Accidental Pump-Stop in Pressure Water Supply Pipeline

Water Hammer Suppression with Variable Terminal Time via PDE-Constrained Dynamic Optimization

Numerical Simulation of the Water Hammer Caused by Accidental Pump-stop in Long Water Supply Systems

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Parameter cooperative matching optimization method for anti-cavitation structure of unloading valve

Water hammer mitigation via PDE-constrained optimization

Study on Water Hydraulic Directional Valve with Plane Piston Structure

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

Simulation and Experimental Investigation on Pressure Dynamics of Pneumatic High-Speed On/off Valves

Numerical Simulation of a Check Valve Closure Induced by Pump Shutdown

Three-dimensional computational fluid dynamics simulation of valve-induced water hammer

Study on optimal water hammer protection for high-head and multi-undulation water conveyance system and empirical formulae for pressure head at nodes

Numerical Simulation and Optimization on Valve-Induced Water Hammer Characteristics for Parallel Pump Feedwater System

Analytical Study on Water Hammer Pressure in Pressurized Conduits with a Throttled Surge Chamber for Slow Closure

AN OPTIMIZATION STUDY ON CAVITATION FLOW IN A STEAM TRAP VALVE

Research on the performance of check valve at a long distance pumping system

Principle and Opening-Closing Character Analysis of DC Check Valve

Minimal Time Of Valve Closure For Fluid Transient In Water Transmission

A study of the numerical simulation of water hammer with column separation and cavity collapse in pipelines

An Experimental Study on the Water Hammer with Cavity Collapse under Multiple Interruptions

Study on Optimal Surge Protection for High-Undulate Long-Distance Water Transmission Pipeline