Abstract:The (1 − x)(Li 0.03 Na 0.5 K 0.47 )(Nb 0.92 Sb 0.05 Ta 0.03 )O 3 –xBa 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (LNKNST–BCZT, x = 0, 0.5, 1.5, 2.5, and 3.5%) lead-free piezoceramics were synthesized by the conventional solid-state reaction method with adding nano-sized Ba 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (BCZT) powder to investigate their influences on crystal structure and electrical properties. The X-ray diffraction (XRD) analysis reveals that all the sintered LNKNST–BCZT ceramics exhibit pure perovskite structure with the mainly rhombohedral (R) phase or the coexistence of rhombohedral (R) phase and tetragonal (T) phase. The composition of the LNKNST–1.5%BCZT ceramics locates around the critical point, i.e., the ceramics changing from the coexistence of rhombohedral (R) phase and tetragonal (T) phase to purely rhombohedral (R) phase, and presents the most densified microstructure morphology, which can be confirmed further by the field emission scanning electron microscope (FESEM) observation. There are two dielectric anomalies in the temperature dependent dielectric properties curves of the LNKNST–BCZT ceramics, which correlate with the ferroelectric rhombohedral (R) phase changing to the ferroelectric tetragonal (T) phase, and then to the paraelectric cubic (C) phase. Both the Curie–Weiss law and the power law fittings confirm the diffuse phase transition ferroelectrics characteristic of the LNKNST–1.5%BCZT ceramics, which is considered as correlating with the polar nanoregions (PNRs). Due to the densification effect caused by the chosen amount of nano-sized BCZT doping and the construction of R–T polymorphic phase boundary, the LNKNST–1.5%BCZT ceramics exhibit the best ferroelectric and piezoelectric properties. The complex impedance spectroscopy analysis confirms that the extrinsic electrical conduction mechanism at high temperatures is dominated by the oxygen vacancies induced by the evaporation of the alkali metals during sintering.

Influence of Sintering Temperature on Grain Growth and Phase Structure of Compositionally Optimized High‐Performance Li/Ta‐Modified (na,k)nbo3 Ceramics

Combined Effects of Li Content and Sintering Temperature on Polymorphic Phase Boundary and Electrical Properties of Li/Ta Co-Doped (na, K)NbO 3 Lead-Free Piezoceramics

Influence of sintering temperature on electrical properties of (K0.4425Na0.52Li0.0375)(Nb0.8825Sb0.07Ta0.0475)O3 ceramics without phase transition induced by sintering temperature

Spark Plasma Sintering of Li/Ta-modified (k,na)nbo3 Lead-Free Piezoelectric Ceramics: Post-annealing Temperature Effect on Phase Structure, Electrical Properties and Grain Growth Behavior

Influences of Sintering Temperature on Piezoelectric, Dielectric and Ferroelectric Properties of Li/Ta-Codoped Lead-Free (Na,K)NbO<sub>3</sub> Ceramics

Enhanced Dielectric and Piezoelectric Properties in Litao3-Doped Lead-Free (k,na)nbo3 Ceramics by Optimizing Sintering Temperature

Phase Structure and Electrical Properties of (Li,ta)-Doped (k,na)nbo3 Lead-Free Piezoceramics in the Vicinity of Na/K = 50/50

Microstructures and Electrical Properties of Knbo3 Doped (li,ta,sb) Modified (k,na)nbo3 Lead-Free Ceramics by Two-Step Sintering

Normal Sintering of (k,na)nbo3‐based Ceramics: Influence of Sintering Temperature on Densification, Microstructure, and Electrical Properties

Effects of nano-sized BCZT on structure and electrical properties of KNN-based lead-free piezoceramics

Effects of the Co-Addition of Li, Sb, Ta on the Phase Structure and Piezoelectric Properties of (Na, K) NbO3 Lead Free Piezoceramics

The Effects of K/Na Ratio on the Electrical Properties of (Li, Sb, Ta) Modified KNN Piezoelectric Ceramics at Reduced Temperature with KNbO3 as Sintering Aid

Enhanced Dielectric and Piezoelectric Properties in Li/Sb-modified (na, K)NbO3 Ceramics by Optimizing Sintering Temperature

Electrical and Mechanical Properties of Fine‐Grained Li/Ta‐Modified (na,k)nbo3‐based Piezoceramics Prepared by Spark Plasma Sintering

Phase Transition Behavior and Electrical Properties of Lead-Free (1−x)(0.98k0.5na0.5nbo3–0.02litao3)–x(0.96bi0.5na0.5tio3–0.04batio3) Piezoelectric Ceramics

Piezoelectric Properties of Low-Temperature Sintered Li-Modified (na, K)Nbo3 Lead-Free Ceramics

Influence of Sintering Temperatures on the Properties of Lithium Sodium Potassium Niobate Piezoelectric Ceramics

Preparation and properties of (Na 0.5+xK 0.5-2xLi x) Nb 0.9Ta 0.1O 3 lead-free piezoelectric ceramics by sol-gel method

Piezoelectric Properties of (K0.44 Na0.52 Li0.04)(Nb0.86 Ta0.10 Sb0.04)O3 Ceramics

Relationship Between Phase Structure and Electrical Properties of (k0.5na0.5)nbo3–litao3 Lead-Free Ceramics

Preparation and Properties of (na_0.48k_0.52)_0.96li_0.04(nb_0.86ta_0.08sb_0.06)o_3 Lead-Free Piezoelectric Ceramics