Abstract:The (1 − x)(Li 0.03 Na 0.5 K 0.47 )(Nb 0.92 Sb 0.05 Ta 0.03 )O 3 –xBa 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (LNKNST–BCZT, x = 0, 0.5, 1.5, 2.5, and 3.5%) lead-free piezoceramics were synthesized by the conventional solid-state reaction method with adding nano-sized Ba 0.85 Ca 0.15 Zr 0.1 Ti 0.9 O 3 (BCZT) powder to investigate their influences on crystal structure and electrical properties. The X-ray diffraction (XRD) analysis reveals that all the sintered LNKNST–BCZT ceramics exhibit pure perovskite structure with the mainly rhombohedral (R) phase or the coexistence of rhombohedral (R) phase and tetragonal (T) phase. The composition of the LNKNST–1.5%BCZT ceramics locates around the critical point, i.e., the ceramics changing from the coexistence of rhombohedral (R) phase and tetragonal (T) phase to purely rhombohedral (R) phase, and presents the most densified microstructure morphology, which can be confirmed further by the field emission scanning electron microscope (FESEM) observation. There are two dielectric anomalies in the temperature dependent dielectric properties curves of the LNKNST–BCZT ceramics, which correlate with the ferroelectric rhombohedral (R) phase changing to the ferroelectric tetragonal (T) phase, and then to the paraelectric cubic (C) phase. Both the Curie–Weiss law and the power law fittings confirm the diffuse phase transition ferroelectrics characteristic of the LNKNST–1.5%BCZT ceramics, which is considered as correlating with the polar nanoregions (PNRs). Due to the densification effect caused by the chosen amount of nano-sized BCZT doping and the construction of R–T polymorphic phase boundary, the LNKNST–1.5%BCZT ceramics exhibit the best ferroelectric and piezoelectric properties. The complex impedance spectroscopy analysis confirms that the extrinsic electrical conduction mechanism at high temperatures is dominated by the oxygen vacancies induced by the evaporation of the alkali metals during sintering.

The Effects of K/Na Ratio on the Electrical Properties of (Li, Sb, Ta) Modified KNN Piezoelectric Ceramics at Reduced Temperature with KNbO3 as Sintering Aid

Effects of Na Excess on the Preparation and Characterization of (K0.5na0.5)nbo3ceramics

Enhanced Dielectric and Piezoelectric Properties in Li/Sb-modified (na, K)NbO3 Ceramics by Optimizing Sintering Temperature

Sintering Behavior and Electrical Properties of the (li, Ta, Sb) Modified (K, Na)NbO3 Lead-Free Ceramics with KNbO3 As Sintering Aid

Effects of nano-sized BCZT on structure and electrical properties of KNN-based lead-free piezoceramics

Influence of Sintering Temperature on Grain Growth and Phase Structure of Compositionally Optimized High‐Performance Li/Ta‐Modified (na,k)nbo3 Ceramics

Microstructures and Electrical Properties of Knbo3 Doped (li,ta,sb) Modified (k,na)nbo3 Lead-Free Ceramics by Two-Step Sintering

Preparation of KNN Based Lead-Free Piezoelectric Ceramics Via Composition Designing and Two-Step Sintering

Effects of the Co-Addition of Li, Sb, Ta on the Phase Structure and Piezoelectric Properties of (Na, K) NbO3 Lead Free Piezoceramics

(Bi0.5na0.5)(zr0.97w0.01fe0.02)o3 Doping Effects on KNN‐based Lead‐free Ceramics Prepared Via Two‐step Sintering Technique

Piezoelectric Properties of Low-Temperature Sintered Li-Modified (na, K)Nbo3 Lead-Free Ceramics

New K0.48Na0.52NbO3–Bi(Zn0.5Zr0.5)O3 Lead-Free Ceramics: Microstructure and Piezoelectricity

Preparation and Characterization on Piezo-/Ferro-electric Properties Of(1-X)(knn+lt)+xbi Ceramics

Normal Sintering of (k,na)nbo3‐based Ceramics: Influence of Sintering Temperature on Densification, Microstructure, and Electrical Properties

Phase Structure and Electrical Properties of (Li,ta)-Doped (k,na)nbo3 Lead-Free Piezoceramics in the Vicinity of Na/K = 50/50

Influence of sintering temperature on electrical properties of (K0.4425Na0.52Li0.0375)(Nb0.8825Sb0.07Ta0.0475)O3 ceramics without phase transition induced by sintering temperature

Effect of Sintering Conditions on the Electrical Properties of Lead-Free Piezoelectric Potassium Sodium Niobate-Based Ceramics

Effect of changing Na/K ratio on structure and electrical properties of (Na xK y) (Nb 0.885Sb 0.08)-0. 035LiTaO 3 lead-free piezoelectric ceramics

Effect of Sintering Temperature on Electrical Properties of Na0.5K0.5NbO3Lead-Free Piezoelectric Ceramics Prepared by Normal Sintering

Influence of Sintering Temperature and Sintering Aid on Electrical Properties of (K, Na)NbO<sub>3</sub>-LT Ceramics

Influence of sintering temperature and sintering aid on electrical properties of (K, Na)NbO3-LT ceramics