Abstract:The aligned film of amorphous carbon (a-C) nanorods was prepared by catalytic chemical vapor deposition (CCVD) on an anodic aluminum oxide (AAO) template at 650 °C. The morphology and microstructure of aligned film of amorphous carbon nanorods were examined by scanning electron microscopy (SEM) and Raman scattering spectroscopy. The friction and wear properties of aligned film of amorphous carbon nanorods on the AAO template in vacuum (1.12×10−1 Pa) were investigated using a ball-on-disk wear tester with aligned film specimen serving as the disk. The ball specimens with 3 mm in diameter were fabricated from a quenched- and -tempered steel. The tests were conducted at loads range from 245 to 1960 mN and at sliding velocities between 0.1 and 0.5 m s−1. Under the vacuum condition, the weight loss of aligned film of amorphous carbon nanorods increased with increasing the applied load, while the friction coefficient decreased gradually as the applied load increased. The aligned film of amorphous carbon nanorods presented good friction stability and low friction, and the values of friction coefficient varied from 0.23 to 0.31 in vacuum. At the same load and sliding velocity, the friction coefficient in vacuum was slightly higher than dry sliding in air.

Micro-Friction Characteristics of Aligned Carbon Nanotube Film on an Anodic Aluminum Oxide Template

Friction and Wear Properties of Aligned Film of Amorphous Carbon Nanorods on Anodic Aluminum Oxide Template in Vacuum

Preparation and friction properties of aligned membrane of amorphous carbon nanorods on AAO template

Tribological Properties of Aligned Film of Amorphous Carbon Nanorods on AAO Membrane in Different Environments

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

Synthesis and frictional properties of array film of amorphous carbon nanofibers on anodic aluminum oxide

Friction and Wear Properties of Array Film of Aligned Carbon Nanorods on Anodic Aluminum Oxide Template in Vacuum

Microtribological Property of Vertically Aligned Carbon Nanotube Film

Tribological Properties of Ta‐C‐N and Ta‐N Thin Films

J2240204 Evaluation of the Properties and Alignment of Carbon Nanotube Sheet Grown by CVD Method

Preparation of Aligned Carbon Nanotubes Film with Even Surface

Friction Properties of Array Films of Amorphous Carbon Nanorods Prepared by Dual-Catalyst Growth on Porous AAO Membrane

Effect of Carbon Nanotube Orientation on Mechanical Properties and Thermal Expansion Coefficient of Carbon Nanotube-Reinforced Aluminum Matrix Composites

Anisotropic Interfacial Friction of Inclined Multiwall Carbon Nanotube Array Surface

Preparation and Modification of Well-Aligned CNTs Grown on AAO Template

Tribological Behavior of Aligned Single-Walled Carbon Nanotubes

Super-Hydrophobicity Of Post-Like Aligned Carbon Nanotube Films

Aligned carbon nanotube/polymer composite film with anisotropic tribological behavior.

Micro-friction behavior of amorphous carbon films on porous AAO membrane synthesized by the pyrolysis of polyethleneglycol 400

Control over the Wettability of an Aligned Carbon Nanotube Film

Influence of Humidity on Microtribology of Vertically Aligned Carbon Nanotube Film