Abstract:Micro-machined electrostatic actuators (MEA) like parallel plate actuators (PPAs) and comb drive actuators (GCAs) are commonly used in many applications, including gyroscopes, resonators and RF switches. The detection of an actuators' mechanical motion is desired when they are combined with feedback control techniques, especially when the application requires high performance or is affected by disturbances. The motion can be detected by a variety of sensing techniques, including capacitive, piezoresistive and optical. Electrostatic parallel plate actuators can be modeled as a type of variable capacitor, which depends on the gap between a fixed electrode and a movable electrode. Thus, the displacement of the actuator can be obtained by measuring the capacitance. However, this practical method often requires high frequency excitation signal sources or additional sensing structures. The excitation power source not only affects the performance in the actuator's steady state, but it may also generate harmonics that distort the measurement signals due to the nonlinear characteristics of the actuator. In addition, the information about velocity may not be obtained without specific sensing structures. The additional structures occupy more space in each die, which could increase the cost and size, or decrease the performance. In this study, an estimator with a series resistor configuration is proposed. The estimator can estimate the displacement and velocity by measuring the voltage of the power supply and the voltage across the actuator itself. To evaluate the feasibility, a nonlinear observability analysis is applied. The analysis shows the observability index among different system states. A simulation study verified the proposed theories.

Sensing Capability of a PZT-driven Cantilever Actuator

Dynamics of A Pzt-Coated Cantilever Utilized As A Transducer for Simultaneous Sensing and Actuating

Self-sensing Principle of Magnetostrictive Actuator

Research of Self-sensing Method Based on the Equivalent Circuit of Giant Magnetostrictive Actuator

The Research of Self-Sensing Magnetostrictive Actuator Based on Parameter Identification

Measurement on the actuating and sensing capability of a PZT microcantilever

Notice of Removal: Fabrication and Analysis of a Flexible PZT-polymer Laminated Composite Cantilever Beam in Sensing and Actuation Modes

An New Instrument for Measuring Mechanical Compliance of Micro-Systems

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

A Hybrid Photovoltaic/flexoelectric Actuation Mechanism Applied to Precision Actuation and Vibration Control of Beams

Design and Fabrication of a High-Speed Linear Piezoelectric Actuator with Nanometer Resolution Using a Cantilever Transducer

Embedded 3d Electromechanical Impedance Model for Strength Monitoring of Concrete Using A Pzt Transducer

Fabrication and Characterization of Microcantilever Integrated with PZT Thin Film Sensor and Actuator

Study on Mechanical-Electric Characteristics of a Cantilever Beam of a Composite PZT Patch

A Two-Dimensional Electromechanical Impedance Model and Experimental Verification of a PZT Transducer

A Three-Dimensional Model of the Effective Electromechanical Impedance for an Embedded PZT Transducer

Nonlinear Observability Analysis of Micro-machined Electrostatic Actuators Using Self-Sensing

A Modified Electro-Mechanical Impedance Model for Dynamic Analysis of PZT Sensor Coupled with Beam Structure

A New Three-Dimensional Electromechanical Impedance Model for an Embedded Dual-Pzt Transducer

A new impedance based sensitivity model of piezoelectric resonant cantilever sensor

High Quality Factor Silicon Cantilever Driven by PZT Actuator for Resonant Based Mass Detection