Abstract:Blank holder force (BHF) is one of the important process parameters in the deep drawing process. BHF helps produce defect-free components by controlling metal flow during the deep drawing process. If BHF is low, it causes wrinkling; otherwise, it causes the sheet to rupture. Therefore, optimization of BHF is an important issue in industries. One of the effective approaches to determining optimal BHF is to study forming force, thickness distribution, and wrinkles to produce a deep-drawn cup. The main function of this approach is that it minimizes the maximum forming force and prevents process limits. Therefore, this study aims to investigate the relationship between the BHF and forming force through experimental and simulation results. In addition, the effect of BHF on the thickness distribution and wrinkling is considered. Hence, numerical and experimental methods were employed for St14 and SS304L sheets with thicknesses of 0.5, 1, and 1.5 mm to achieve the objectives. Firstly, the simulation of the process was performed to study the mechanical behavior. Then, a set of experimental tests were conducted to validate the simulations. Finally, utilizing the experimental and numerical results, the optimal BHF value was determined. It was observed that the maximum thinning and maximum forming force are related to the forming process without BHF. Moreover, when the wrinkling at the edge of the part was removed by gradually increasing BHF, the minimum values of forming force and thinning were obtained. According to the investigations carried out on three thicknesses, it was observed that by reducing the thickness from 1.5 to 0.5 mm, the maximum forming force decreases in both SS304L and St14 sheets. However, the acquired results showed that the minimum optimal BHF is obtained in both sheets at a thickness of 1.5 mm. Overall, this research provides valuable experimental and numerical guidance for implementing the deep drawing process to manufacture cylindrical parts with minimum forming force required to save energy consumption.

Research on influence factors of forming force in medium-thick sheet metal extrusion process

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Effect of the Friction on the External High Pressure Forming of Metal Stator Screw Lining

An Experimental Study on Local Thickening Laws Based on Multi-Plate Extrusion

Study on Metal Forming Patterns of the Ultrasonic Vibration Assisted Upset-extruding Process

Investigation on the Factors Influencing the Thickness Distribution of Superplastic-Formed Components

FEM model optimization study of mechanical properties and material selection in stamping process

Research on the Mechanism and Processability of Roll Forming

An investigation on the friction in a micro sheet metal roll forming processes considering adhesion and ploughing

Influence of ultrasonic vibration on forming force of 1060 aluminum sheet single point incremental forming

A Novel Method for Friction Coefficient Calculation in Metal Sheet Forming of Axis-Symmetric Deep Drawing Parts

Establishment of a constitutive model for the solid granules medium and its application in sheet metal forming

Effect of process parameters on the deep drawing formability of aluminum and advanced high-strength steel square cups

Numerical Simulation and Process Optimization of Internal Thread Cold Extrusion Process

Research on the influencing factors of small bending radius elbow stamping based on CAE simulation

Investigation into the sheet metal forming process using solid granules medium with graphite powder addition

Research on the Critical Blank Holder Force of Elliptical Heads

Study on hydroforming of AA6061-T6 aluminum alloy sheet based on upper sheet

Research on the hydroforming law of variable cross-section shaped tubular automobile longitudinal arm

Experimental and numerical investigation to determine the optimal blank-holder force in deep drawing process based on forming force for SS304L and St14 sheets

Research on incremental forming simulation based on an improved constitutive model