Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

A Novel Frequency Selective Surface Loaded with Resistance Films Absobers

A Wideband Transmission Frequency Selective Surface Rasorber

Multi-characteristic Integrated Ultra-wideband Frequency Selective Rasorber

Design of an Invisible Radome by Frequency Selective Surfaces Loaded with Lumped Resistors

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

Status and Development of Frequency Selective Surface Radome

Design of a Tunable Low-Frequency and Broadband Radar Absorber Based on Active Frequency Selective Surface

A Novel Angularly Stable Wide Passband Frequency Selective Surface

A Thin and Broadband Tunable Radar Absorber Using Active Frequency Selective Surface

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

Filtenna-Filtenna Design for Broadband and High-Selectivity Frequency Selective Surface

Frequency Selective Rasorber with Broadband Transmission Window Using Characteristic Modes Analysis

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Surface Impedance Modulation of FSS Composite Absorber for RCS Reduction at Normal and Grazing Incidence

Tunable frequency selective radome with broadband absorbing properties

A planar stealthy antenna radome using absorptive frequency selective surface

A Novel Tunable Frequency Selective Surface Absorber with Dual-Dof for Broadband Applications.

Switchable Frequency Selective Surfaces Absorber/reflector for Wideband Applications

An FSS-Integrated Low-RCS Radome Design

Design of Frequency-Selective Surfaces Radome for a Planar Slotted Waveguide Antenna