Investigation of Microstructure and Mechanical Properties of AZ91 Magnesium Alloy Produced by Directional Solidification Method in Different Angles Using CAFE Simulation
M. Khosroaghayani,M. Khorasanian,S. R. Alavi Zaree,M. Eskandari
DOI: https://doi.org/10.1007/s40962-022-00766-0
2022-02-09
International Journal of Metalcasting
Abstract:The present research aim was to study the microstructure and mechanical properties of AZ91 magnesium alloy and to investigate the grain size and shape, as well as the distribution and morphology of Mg17Al12 in the directional solidification process. In the first part of the present research, sample production of AZ91 alloy was performed using a directional solidification process. In the second part, the microstructure of the samples was investigated with cutting angles of 0°, 30°, 45°, 60°, and 90° from the heat transfer axis. In order to better analyze the results, CAFE simulation by ProCAST software was used. By increasing the distance from the chill and passing the transition boundary (22 mm), grain density decreased. Also, by increasing the angle of deviation, the grain elongation decreased over time, and approached the equiaxed mode. As the angle increased, the sphericity of the grains increased as well. At various angles, the shape and morphology of the Mg17Al12 phase were different. By increasing the angle, the length of the phases was reduced and their thickness and sphericity increased. By increasing the angle, the ultimate compressive strain decreased. Since the maximum shear stress occurs at an angle of 45°, therefore, with the increase in fracture in grain boundaries, at angle of 45°, the fracture has occurred earlier. The yield stress at a 45° angle was higher than at other angles. In brief, the grain texture and mechanical properties of the alloy were greatly affected by directional solidification.
metallurgy & metallurgical engineering