Abstract:Die forging is a processing method that can produce a size and shape close to the finished product and improve the mechanical properties of the alloy. In this paper, Mg–8Al-0.5Zn magnesium alloy was used to prepare stepped shaft by isothermal die forging. The microstructure and stress-strain state of different parts of stepped shaft forging were analyzed. The metal rheological law and microstructure evolution mechanism of AZ80 alloy during die forging were discussed. At the position of low stress and high strain state of the die forging, continuous dynamic recrystallization (CDRX) is the main deformation mechanism, and the microstructure is mainly composed of coarse un-dynamic recrystallized (unDRXed) grains and fine equiaxed dynamic recrystallized (DRXed) grains. The unDRXed grains have a strong basal texture, while the DRXed grains exhibit random orientations. At the position of high stress and low strain state of the die forging, {10–12} twinning is the main deformation mechanism, the parent grains show a strong basal texture, while {10–12} twins present [-12-10]-[01–10] double fiber texture parallel to forging direction (FD). The compressive strength and yield strength of the part in the low stress and high strain state are higher than those in the high stress and low strain state, but the fracture strain of the former is lower than that of the latter. The results of this study can provide a reference for the design of die forging die together with the blank shape and size, so as to meet the corresponding performance requirements of different parts of the die forging.

Research on Structure Property of AZ91D Magnesium Alloy Produced by Liquid Combination Process of Die Casting and Forging

Microstructure and Properties of AZ91D Magnesium Alloy in Combination Process of Die Casting with Forging

Research on the Comparison of the Macroscopic Defect and the Mechanical Property of AZ91D Magnesium Alloy Parts Produced by Liquid Combination Process of Die Casting and Forging and Liquid Die Casting

Forming Technique of Magnesium Alloy Parts Produced by Liquid Combination Process of Die Casting and Forging

Microstructures and Mechanical Properties Ofaz91d Magnesium Alloy Processed by Low Pressure Die Casting

Investigation of Properties in Magnesium Alloy Thin Plates after Die Casting Processes

Processing Technology and Mechanical Properties of Die-Cast Magnesium Alloy AZ91D

On the Deformation Behavior of Heterogeneous Microstructure and Its Effect on the Mechanical Properties of Die Cast AZ91D Magnesium Alloy

Study on Mechanical Properties of Vacuum Die-cast AZ91D Magnesium Alloy

Semi-solid Slurry Preparation, Rheo-Die Casting and Rheo-Squeeze Casting of an AZ91–2Ca–1.5Ce Ignition-Proof Magnesium Alloy by Gas-Bubbling Process

Effect of Primary Microstructure on Re-Melting Behavior of AZ91D Magnesium Alloy

Research On Alloying Tecniques Of Mischmetal In Die Casting Magnesium Alloy

Mechanical Properties and Microstructures of Mg-Al-Zn Alloys with High Aluminum Contents

Study on Structure and Corrosion Resistance of AZ91 Magnesium Alloy in Lost Foam Casting Process

Effects of processing parameters on grain size in die casting magnesium alloy AZ91HP castings

Study on Processing Conditions for Semi-Solid Forging of Magnesium Alloys

INFLUENCE OF SOLUTION AND AGING ON MECHANICAL PROPERTIES OF AZ91HP DIE-CASTING ALLOY

Study on the Microstructure and Properties of AZ31 Alloy by Hot Die Forging Extrusion

Microstructure and Mechanical Properties of AZ31 Magnesium Alloy Processed by Cyclic Closed-Die Forging

Microstructure Evolution and Deformation Mechanism of AZ80 Alloy During Die Forging