Abstract:In this study, the cooperative effect of Mg and Si contents on the microstructural evolution, mechanical properties, and deformation behavior of the cast Al–Li–Mg–Si alloys is investigated. Five different Al–Li–Mg–Si alloys are prepared by conventional casting method, which are referred to as Alloy A-E. The results show that with the increase in the Mg content, the amount of lath-like Mg2Si precipitates and bulk-like AlLiSi particles increases, which leads to an improvement in the strength and ductility of alloys. The amount of intergranular Si-rich phases in Alloy D increases with the increase in the Si content. Further, a higher Si content in Alloy E promotes the formation of bulk-like AlLiSi. The geometric phase analysis (GPA) results reveal strain partitioning behavior at the interface of Mg2Si precipitates and AlLiSi particles, which follows the Orowan looping or dislocation cutting strengthening mechanism. The geometrically necessary dislocation (GND) density calculation results suggest that the lath-like Mg2Si precipitates play a critical role in the deformation behaviors of Alloy A-C. The hindering effect of lath-like Mg2Si precipitates on the movement of dislocations decreases the GND density gap between high-angle grain boundaries or junctions and grain interior and improves the resistance to deformation. However, the deformation behaviors of Alloy D and E with higher Si content are mainly governed by the intergranular Si-rich phases. Finally, a methodological framework is established to elucidate the effect of precipitates and/or intergranular phases on the deformation behaviors of materials using a combination of GPA and GND density calculation methods.

Effect of silicon on damping capacities of pure magnesium and magnesium alloys

EFFECT OF THE ADDITION OF REINFORCEMENTS ON DAMPING CAPACITY OF PURE MAGNESIUM

Influence of Sb on damping capacity and mechanical properties of Mg2Si/Mg–9Al composite materials

Research on the dislocation damping of Mg2Si/Mg–9Al composite materials

Effect of Mg on Nucleation Process of Recrystallization in Al–Mg–Si/SiCp Composite

Low Frequency Damping Capacities and Mechanical Properties of Mg–Si Alloys

A Study on the Damping Capacities of Mg–Zn–Y-Based Alloys with Lamellar Long Period Stacking Ordered Phases by Preparation Process

Microstructure and damping properties of Mg–Si binary hypoeutectic alloys

Effects of Si Content and Modification on Microstructure and Properties of In-situ Mg2Si/Mg Composites

Strengthening Mechanism and Damping Properties of SiCf/Al-Mg Composites Prepared by Combining Colloidal Dispersion with a Squeeze Melt Infiltration Process

Damping capacity of pure magnesium matrix composites

Effect of Mg addition on the microstructure and mechanical properties of MoSi2 alloys

Low Frequency Damping Behaviors of Magnesium Alloys

Cooperative Effect of Mg and Si Contents on the Microstructural Evolution, Mechanical Performance, and Deformation Behavior of Cast Al–Li–Mg–Si Alloys

Damping capacity of magnesium matrix composites fabricated by ultrasonic-assisted stir casting

(Aln + Mg2si)/Mg Composites in Situ Synthesis and Scale Effect of Particulate on Damping Capacity

Precipitation behavior and damping characteristic of Mg–Al–Si alloy

Effect of Sb doping on microstructure, mechanical and electronic properties of Mg2Si in Mg2Si/AZ91 composites by experimental investigation and first-principles calculation

Effects of silicon on microstructure, fluidity mechanical properties, and fracture behaviour of Mg-6Alalloy

Influence of Li2sb Additions on Microstructure and Mechanical Properties of Al-20mg(2)Si Alloy

Damping Capacity Associated with Precipitation in Mg2Si/Mg–9Al Composite Materials