Abstract:As HDS catalysts, the supported catalysts including oxide state Mo, Co–Mo and sulfide state Mo on carbon nanotube (CNT) were prepared, while the corresponding supported catalysts on γ-Al2O3 were prepared as comparison. Firstly, the dispersion of the active phase and loading capacity of Mo species on CNT was studied by XRD and the reducibility properties of Co–Mo catalysts in oxide state over CNTs were investigated by TPR while the sulfide Co–Mo/CNT catalysts were characterized by XRD and LRS techniques. Secondly, the activity and selectivity of hydrodesulfurization (HDS) of dibenzothiophene with Co–Mo/CNT and Co–Mo/γ-Al2O3 were studied. It has been found that the main active molybdenum species in the oxide state MoO3/CNT catalysts were MoO2, rather than MoO3 as generally expected. The maximum loading before formation of the bulk phase was lower than 6%m (calculated in MoO3). The TPR studies revealed that that active species in oxide state Co–Mo/CNT catalysts were more easily reduced at relatively lower temperatures in comparison to those in Co–Mo/γ-Al2O3, indicating that the CNT support promoted the reduction of active species. Among 0–1.0 Co/Mo atomic ratio on Co–Mo/CNT, 0.7 has the highest reducibility. It shows that the Co/Mo atomic ratio has a great effect on the reducibility of active species on CNT and their HDS activities and that the incorporation of cobalt improved the dispersion of molybdenum species on CNT and mobilization. It was also found that re-dispersion could occur during the sulfiding process, resulting in low valence state Mo3S4 and Co–MoS2.17 active phases. The HDS of DBT showed that Co–Mo/CNT catalysts were more active than Co–Mo/γ-Al2O3 and the hydrogenolysis/hydrogenation selectivity of Co–Mo/CNT catalyst was also much higher than Co–Mo/γ-Al2O3. For the Co–Mo/CNT catalysis system, the catalyst with Co/Mo atomic ratio of 0.7 showed the highest activity, whereas, the catalyst with Co/Mo atomic ratio of 0.35 was of the highest selectivity.

Study on Selective Hydrodesulfurization Catalysts for Fluid Catalytic Cracking Gasoline Using In-Situ Infrared

Catalytic Characteristics of Active Corner Sites in CoMoS Nanostructure Hydrodesulfurization – A Mechanism Study Based on DFT Calculations

Ex-situ Presulfiding of Hydrotreating Catalysts

Mesoporous Carbon Supported Co-Mo and Ni-Mo Catalysts for Hydrodesulfurization

Catalysis by Sulfides: Advanced IR/CO Spectroscopy for the Identification of the Most Active Sites in Hydrodesulfurization Reactions

XPS Characterization of Carbon Nanotube Supported CoMo Hydrodesulfurization Catalysts

Hydroisomerization of Model FCC Naphtha over Sulfided Co(Ni)–Mo(W)/MCM-41 Catalysts

Synthesis of alumina-nitrogen-doped carbon support for CoMo catalysts in hydrodesulfurization process

In situ FT-IR study of thiophene adsorbed on the surface of sulfided Mo catalysts

Catalytic Performance in Hydrodesulfurization of Thiophene and Ir Investigation of Co and No Adsorption over Co−Mo/Al2O3 and Ru−Co−Mo/Al2O3 Catalysts

Study on the hydrodesulfurization active phase in sulfided NiW/Al2O3 catalyst. III. Low-temperature FT-IR spectroscopy of adsorbed CO

States of Carbon Nanotube Supported Mo-Based HDS Catalysts

Comparative Study on Molybdenum Nitride, Phosphide and Carbide

Electronic structure regulation of CoMoS catalysts by N, P co-doped carbon modification for effective hydrodesulfurization

Hydroisomerization of Model Naphtha over Sulfided Co-Mo/SBA-15 Catalyst

Hydrodesulfurization of Thiophene on Ni, Mo-Supported Mcm-41 Catalysts

Preparation of Co-Mo/γ-Al2O3 catalyst and the catalytic hydrogenation effects on coal-related model compounds

Synergistic effect between CoS x and MoS 2 at the micrometer scale: Considerable promotion of the hydrodesulfurization of DBT

Influence of Active Phase Structure of CoMo/Al2O3 Catalyst on the Selectivity of Hydrodesulfurization and Hydrodearomatization

FT-IR Study of Carbon Nanotube Supported CoMo Catalysts

Enhanced hydrodesulfurization activity of thiophene over hollow tubular CoMo unsupported catalysts