Abstract:Recycled aggregate concrete is a promising low carbon material, which need further analysis on the durability. To investigate the influence of sulfate erosion on recycled concrete made with high-belite sulfoaluminate cement (HBCSA), this study utilized compressive strength and microhardness test to evaluate the effect of sulfate on ITZ. Then by using backscattered electron imaging, scanning electron microscope and energy spectrometry, the mechanism for the microstructural changes that occurred before and after sulfate erosion is revealed. Results showed that after 60 days of sulfate erosion, both aggregate-new mortar and new–old mortar interfaces display reduced microhardness and widened transition zones. Specifically, in the C30 group post-erosion, the microhardness values for the aggregate-new mortar interface ranged from 50.3 to 66.9 MPa, while the new–old mortar interface exhibited a range of 47–77 MPa. Besides, the new–old mortar interface exhibit marginally superior sulfate resistance to the aggregate–new mortar interface at the same concrete strength grade. Moreover, sulfate resistance improvs across all interfaces with increasing strength class. For instance, in the aggregate-new mortar interface, the maximum microhardness post-erosion for C40 showed a 51.6 % increase compared to C30. Through microstructure analysis, it is found that after sulfate erosion, the aggregate–new mortar and new–old mortar interfaces of HBCSA recycled concrete are both enriched with abundant ettringite and gypsum, which causes considerable swelling erosive product formation and even cracking. The less formed cracks in new–old mortar interfaces results in the better sulfate resistance. The finding is helpful for the future research on the high sulfate resistant recycled aggregate concrete.

Study on the Cement Mortar Which is Damaged by Low Temperature and Eroded by Carbonate and Sul

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Degradation mechanism of cement mortar exposed to combined sulfate–chloride attack under cyclic wetting–drying condition

Attack of Limestone Cement-Based Material Exposed to Magnesium Sulfate Solution at Low Temperature

Impact of the Thaumasite Sulfate Attack on the Pore Structure and Gas Permeability of Cement Mortar

Properties evolution of calcium sulfoaluminate cement blended with ground granulated blast furnace slag suffered from sulfate attack

Change of the Coefficient of Thermal Expansion of Mortar Due to Damage by Freeze Thaw Cycles

Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete in Marine Tidal Zone

Thaumasite form of sulfate attack in ettringite rich-ternary systems: Effects of limestone filler, etching solutions and exposure temperature

Relationship Between Microscopic Pore Structure and Strength of Cement-Based Materials with Low Water-Binder Ratio Under Sulfate Attack Environment

Influence of Super Absorbent Polymer on the Sulfate Resistance of Cement Mortar

Sulfate resistance and hydration products of steam cured steel slag blended cement mortar under dry–wet cycle

Form and mechanism of sulfate attack on cement-based material made of limestone powder at low water-binder ratio under low temperature conditions

Effect of sulfate attack on multiple interfacial transition zones of high-belite sulfoaluminate cement recycled concrete

Study of seawater corrosion resistance of ordinary Portland cement–aluminate cement–gypsum mortar containing slag

Investigating the sulfate resistance of mortars with multiple mineral admixtures in ammonium-magnesium sulfate solution

Analysis of Sulfate Substance Penetration into the Surface Area of Hardened Cement Mortar and Its Reaction Products

Effect of Fly Ash on TSA Resistance of Cement-Based Material

Mechanical characteristics and freezing-thawing degradation mechanism for mortar samples under sodium sulfate solutions attack

Effect of Sulphur-Containing Tailings Content and Curing Temperature on the Properties of M32.5 Cement Mortar

Deterioration of alkali-activated and Portland cement-based mortars under sulfur oxidizing bacteria corrosion