Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Metastable flow of R12 through capillary tubes

Numerical Simulation and Experimental Study of Capillary Tubes

Visualization of R1233zd(E) Flow Boiling in Parallel Mini-channels

STUDY ON FLOW BEHAVIOR OF R22 ALTERNATIVE REFRIGERANT IN CAPILLARY TUBE

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Study on Characteristic of the Two-Phase Flow of Refrigerant in a Capillary

Experimental Study on the Flow Condensation Heat Transfer of R290 and R22 in a Horizontal Circular Minitube

Simulation on the Performance of Adiabatic Capillary Tubes With R410A Refrigerant

NUMERICAL CALCULATION OF FLOW IN ADIABATIC CAPILLARY TUBE OF ALTERNATIVE REFRIGERANTS

Condensation heat transfer and pressure drop characteristics inside smooth and enhanced tubes with R410A and R32

Experimental Study on the Flow Boiling Heat Transfer and Pressure Drop of Refrigerant R32 in Horizontally Oriented Small-Diameter Tubes

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Comparison Between Homogeneous and Separated Flow Models of Isobutane Flowing Through Adiabatic Capillary Tubes

R410A and R32 condensation heat transfer and flow patterns inside horizontal micro-fin and 3-D enhanced tubes

Experimental Study of Flow Boiling Heat Transfer in Mini-Tube

Numerical simulation of coiled adiabatic capillary tubes in CO2 transcritical systems with separated flow model including metastable flow

Studies on low GWP refrigerants flowing through capillary expansion devices used in refrigeration systems

Effect of Vapor Flow on the Falling Film Evaporation of R134a Outside A Horizontal Tube Bundle

Condensation Heat Transfer Experiments of R410A and R32 in Horizontal Smooth and Enhanced Tubes

Characteristic of Flashing Flow of Refrigerant in a Capillary

Experimental Investigation of R410A and R32 Falling Film Evaporation on Horizontal Enhanced Tubes