Numerical Simulation on the Fine Particle Charging and Transport Behaviors in a Wire-Plate Electrostatic Precipitator
Quanyang Lu,Zhengda Yang,Chenghang Zheng,Xiang Li,Chong Zhao,Xi Xu,Xiang Gao,Zhongyang Luo,Mingjiang Ni,Kefa Cen
DOI: https://doi.org/10.1016/j.apt.2016.06.021
IF: 4.969
2016-01-01
Advanced Powder Technology
Abstract:In this work, an integrated numerical model is presented and validated to investigate the particle charging and transport behaviors in a wire-plate electrostatic precipitator (ESP). Calculations of gas flow, electrostatics field and particle motions are coupled in the model, and the influences of electro-hydrodynamics (EHD) flows are also taken into account. The dynamic charging process of particles was treated with separate field and diffusion charging rates, and the trajectories of particles in the ESP were tracked with a Lagrangian-type method. Numerical results show that electric field strengths and charging ion densities varied largely in the computational domain, and inlet particles were initially charged primarily by diffusion charging mechanism. The particles were then charged to a near saturation state in the discharging zone, while their transverse velocities showed considerable fluctuations along the trajectories. Numerical results indicate that particles with diameter between 0.2 and 1 gm normally exhibited lowest average transverse velocities, and longer residential time could slightly improve the transverse velocities for all sizes of particles. Moreover, increasing voltages could greatly improve the acquired charges and collecting performances for particles larger than 1 gm, while higher ion current value was more effective in achieving higher collection efficiencies for sub-micron particles. (C) 2016 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.