Abstract:An air-breathing micro direct methanol fuel cell (mu DMFC) with a water collecting and recycling cathode structure is presented in this paper. The mechanism of water generation in cathode and water collection from the cathode is studied. The capillary channels with hydrophilic surface are designed along the ribs of the air-breathing cathode window to collect excessive water. The collected water is then released via an exhaust pipe. Microfabrication techniques, including double-side lithography and KOH etching, are used to fabricate the anode and cathode plates of the mu DMFC on the same silicon wafer simultaneously. The silicon plate surface is treated by low temperature oxygen plasma to improve the hydrophilicity. The mu DMFC with the water collecting and recycling structure and the regular one without, both with an active area of 7.8 x 7.8 mm(2), are assembled and characterized. Experimental results show that the maximum power density and current density of the both mu DMFCs are more than 10 mW cm(-2) and nearly 100 mA cm(-2) at room temperature, respectively. After both mu DMFCs operate at 0.15 V (about 60 mA cm(-2) at room temperature) for 1 h, the outputs of the prototype with water collecting and recycling structure decrease to about 9.7 mW cm(-2) and 95 mA cm(-2) only, while that of regular one decrease to 9 mW cm(-2) and 75 mA cm(-2). The water is collected by the exhaust pipe in evidence. As such, it would be possible to recycle the water from cathode to anode. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Development of Anodic Flux and Temperature Controlling System for Micro Direct Methanol Fuel Cell

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

Optimized temperature control system integrated into a micro direct methanol fuel cell for extreme environments

A Micro Direct Methanol Fuel Cell Integrated with a Temperature Control System for Extreme Environments

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

Development of a Microwave Sensor for Real-Time Monitoring of a Micro Direct Methanol Fuel Cell

Development of Integrated Thermally Autonomous Reformed Methanol-Proton Exchange Membrane Fuel Cell System

A Methanol Fuel Processing System with Methanol Steam Reforming and CO Selective Methanation Modules for PEMFC Application

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

Numerical simulation on mass transport in a passive vapor-fed direct methanol fuel cell operating with neat methanol

Evaluation of structural aspects and operation environments on the performance of passive micro direct methanol fuel cell

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

Micro direct methanol fuel cell: functional components, supplies management, packaging technology and application

Design and Fabrication of Fuel-Self-Propelled Reaction Device for Passive Micro Direct Methanol Fuel Cell Anodes

A Water Collecting and Recycling Structure for Silicon-Based Micro Direct Methanol Fuel Cells

Design and Utilization of a Direct Methanol Fuel Cell

Methanol Concentration Control Strategies for Direct Methanol Fuel Cells

A Micro-Reactor with Micro-Pin-fin Arrays for Hydrogen Production Via Methanol Steam Reforming

An Air-Breathing Micro Direct Methanol Fuel Cell with 3D KOH-Etched Cathode Structure

Capillary-based Water Removal Cathode for an Air-Breathing Micro Direct Methanol Fuel Cell

Fuel-delivery System and Control of Portable Direct Methanol Fuel Cell