Abstract:This paper presents a sandwich structure for a capacitive pressure sensor. The sensor was fabricated by a simple three-mask process and sealed in vacuum by anodic bonding. The sensor, which utilizes a combined SiO/sub 2//Si/sub 3/N/sub 4/ layers as the elastic dielectric layers, exhibits high sensitivity. Mechanical characteristics of the sensor are theoretically analyzed based on a composite membrane theory and evaluated by use of finite element analysis (FEA). Square membrane sensors with side lengths of 800 /spl mu/m, 1000 /spl mu/m, 1200 /spl mu/m, and 1500 /spl mu/m were fabricated, providing a measured sensitivity of 0.08 pF/kPa, 0.12 pF/kPa, 0.15 pF/kPa, and 0.2 pF/kPa, respectively. The nonlinearity of the sensor is less than 1.2% over a dynamic range 80-106 kPa and the maximum hysteresis is about 3.3% to the full scale capacitance change. The TCO at 101 kPa is 1923 ppm//spl deg/C. All the electrodes of the sensor are leaded from the top side of the chip. Residual pressure in the sealed cavity at room temperature is evaluated by a pressure scanning test, indicating about 8 kPa. Comparison of experimental results with theoretical analysis shows that change of capacitance for the sandwich structure under pressure is mainly due to variation of the dielectric constant while geometric variations such as the area change of electrodes and the thickness change of dielectric layers is about two orders less than the variation of the dielectric constant. Sensitivity enhancements for the sensor are qualitatively discussed based on the physical effects of strained dielectrics, including electrostriction and flexoelectricity. [1551].

Modeling, Design and Fabrication of a Triple-Layered Capacitive Pressure Sensor

A Capacitve Pressure Sensor with a Novel Multi-Layered Composite Membrane Strucutre Fabricated by a Three-Mask Process

A Novel Capacitive Pressure Sensor Based on Sandwich Structures

Design, Fabrication and Test of a Monolithic Capacitive Pressure Sensor

Design of A Novel CMOS Capacitive Absolute Pressure Sensor

A novel monolithic CMOS capacitive pressure sensor

Device Modeling and Optimization of MEMS Based Capacitive Pressure Sensor

The Design and Numerical Simulation of a 3D-Printed Flexible Capacitive Pressure Sensor with a Composite Structure

Wafer-Level Self-Packaging Design and Fabrication of MEMS Capacitive Pressure Sensors

A Fully Integrated Capacitive Pressure Sensor with High Sensitivity

Design and simulation of integrated CMOS-compatible capacitive absolute pressure-sensing microsystems

A MEMS capacitive pressure sensor compatible with CMOS process

Design of Capacitive Pressure Sensors Integrated with Anisotropic Wedge Microstructure-Based Dielectric Layer

A highly sensitive flexible capacitive pressure sensor with hierarchical pyramid micro-structured PDMS-based dielectric layer for health monitoring

The Design of a High Precision Capacitive Pressure Sensor Based on Comb Electrode

A Capacitive Pressure Sensor Based on LTCC/PDMS Bonding Technology

Optimal design parameter estimation and analytical investigation of MEMS quadruple touch mode capacitive pressure sensor

Numerical Simulation Analysis of Microstructure of Dielectric Layers in Capacitive Pressure Sensors

A Flexible and Highly Sensitive Capacitive Pressure Sensor with Fast Response based on a Hierarchically Micro-structured PDMS Dielectric Layer

Modeling the Flexible Capacitive Pressure Sensor with a Polymer Composite Dielectric Layer

Multilayer Self-filled Iontronic Pressure Sensor with Ultrahigh Sensitivity and Broad Sensing Range